Page 2
(6) The customer shall bear the cost of shipping the product to the Customer Service Department of LG. LG shall bear the cost of shipping the product back to the consumer after the completion of service under this limited warranty.
Page 3
For Your Safety Important Information Turn off your phone in a medical facility or at a gas station. Never place your phone in a microwave oven as this will This user guide contains important information on the use and cause the battery to explode. operation of this phone.
Page 4
Only use the batteries, antennas, and chargers provided by bathroom. LG. The warranty will not be applied to products provided by other suppliers. Never store your phone in temperatures less than- 4°F or greater than 122°F.
Page 5
For Your Safety FCC RF Exposure Information Body-worn Operation WARNING! Read this information before operating the phone. This device was tested for typical body-worn operations with the back of the phone kept 0.6 inches (1.5cm) between the In August 1996, the Federal Communications (FCC) of he United user’s body and the back of the phone.
Page 6
For Your Safety Vehicle Mounted External Antenna Battery Disposal (optional, if available) Please dispose of your battery properly or bring to your A minimum separation distance of 8 inches (20cm) must be local wireless carrier for recycling. maintained between the user/bystander and the vehicle Do not dispose in fire or with hazardous or flammable mounted external antenna to satisfy FCC RF exposure materials.
SUBJECT The phone LX360 has been designed to operate on the latest digital mobile communication technology, Code Division Multiple Access (CDMA). The phone LX360 support fully Multimedia - Dual color LCDs, 64poly Audio, 1.3M pixels Digital Camera, MPEG-4, Photo album, etc.
Introduction Highlights Important Information Check Accessories Before You Start Safety Instructions SUBJECT ..................4 Introduction..................7 Highlights....................7 Important Information ................7 Check Accessories ..................7 Safety Instructions ..................8 FCC RF Exposure Information ..............8 Body-worn Operation................. 8 Vehicle Mounted External Antenna (optional, if available.) ....8 FCC Part 15 Class B Compliance..............
Page 9
Roaming With Your Phone ..............17 Calling Experience ................... 18 Correcting Dialing Mistakes ..............18 In Call Options ..................19 Incoming Call Notification ............... 20 Answering Calls ..................20 Displaying Your Phone Number(phone book – not functioning) ..21 Setting the Ring Volume to Vibrate............21 Getting the Most From Service오류! 책갈피가...
Introduction Highlights Congratulations! Your new mobile phone will change your way of communicating and is a compact, lightweight personal communication system with added features for the person on the go. Our advanced digital mobile communication technology allows you to do the followings 1) Main Chipset : MSM6550, Memory(1Gbits NAND Flash + 256Mbits LP-SDRAM) 2) Display : Main LCD(320 x 256 pixels, 2.2 inch, 0.135 dot pitch, 262K colors TFT) Sub LCD(128 x 160 pixels, 1.3 inch, 0.162 dot pitch, 65Kcolors TFT)
Before You Start Safety Instructions WARNING! To reduce the electric shock, do not expose your phone in high humidity areas, such as the bathroom, swimming pool. IMPORTANT! Please read the SAFETY AND GENERAL INFORMATION on page 68 prior to using your phone. FCC RF Exposure Information WARNING! Read this information before operating the phone In August 1996 the Federal Communications (FCC) of the United States with its action in Report...
For more information about RF exposure, please visit the FCC website at www.fcc.gov FCC Part 15 Class B Compliance This device and its accessories comply with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device and its accessories may not cause harmful interference, and (2) this device and its accessories must accept any interference received, including interference that cause undesired operation.
Caution For Adapter (Charger) Use Using the wrong battery charger could cause damage to your phone and void your warranty may burst causing injury to person and damage. The charger or adapter is intended for indoor use only. The charger or adapter is intended for indoor use only. Do not expose the battery charger or adapter to direct sunlight nor use it in any place of high humidity, such as the bathroom.
Getting Started Unlocking Your Phone If you received your LX360 in the mail, you may need to unlock it before making calls. 1. Press the END/PWR Switch for 2~3 seconds. 2. Press soft key Unlock. 3. Enter your four-digit lock code. For security purposes, the code will not be visible as you type.
Installing and Removing the Battery To install the battery, insert the bottom of the battery into the opening on the back of the phone. Then, push the battery down until the latch clicks. To remove the battery, press down on the latch and remove the battery from the phone. Turning Your Phone On and Off To turn your phone on, move the On/Off Switch (near the antenna) to the ON position.
Menu Navigation The Mouse Key lets you scroll circularly through menus quickly and easily. (Highlighted Test Example As you navigate through a menu, the options are highlighted ) . Select an option by highlighting it and pressing . The scroll bar at the right of the menu keeps track of your position in the menu at all times.
Page 17
After a character is entered, the cursor automatically advances to the next space after two seconds. You can also advance the cursor by pressing or entering a character not on the same key. If you make a mistake, press to move the cursor left or [CLR] to erase a character. To clear the entire entry, press and hold [CLR] for two seconds.
Display Icons Display icons are the symbols your phone uses to communicate important information. They are as follows: ICON DESCRIPTION 3G send 3G receive 3G send receive Alarm Battery Antenna In use No service Location Location out Voice Voice Privacy Vibrate Roaming Ringer...
Signal Strength icon informs you of the current strength. The more bars, the stronger the signal. Battery Capacity Your LX360 is equipped with a Lithium Polymer battery. It allows you to recharge your battery before it is fully drained. The battery provides approximately 180 minuets of continuous digital talk time or approximately 110 hours of continuous digital standby time.
Using the AC Adapter To charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the phone via the I/O Connector on the bottom of the phone. Alternatively, you can place the phone in the charging cradle provided with your phone and connect the AC Adapter to the back of the cradle.
Calling Experience When you use your phone on other PCS CDMA networks, your calling experience and call quality will be quite similar to what you experience when making calls within the Network. Although certain calling features may not be available, your phone calls are still private and secure. Correcting Dialing Mistakes To delete one digit at a time, press .
2- Second pause – Inserts a two-second pause. (See “ Dialing and Saving Phone Numbers With Pauses” ) Exit – Returns to the Main Menu. A Phone Book Entry – Displays the Phone Book entry. To dial the entry’s speed-dealing number, press and hold [SEND].
Incoming Call Notification Depending on your settings, your phone notifies you of incoming calls in the following ways: The phone rings or vibrates The LED flashes green The backlight illuminates The screen displays an incoming call message The phone number of the caller is displayed of the phone number is available The caller’s name is displayed if the phone number is in your Phone Book The following options are also displayed.
Displaying Your Phone Number(phone book – not functioning) To display your phone number: 1. From the Main Menu, select SETTING & TOOLS. 2. And press 4 – 2 – 1. (System – Device Info – My Phone Number) Setting the Ring Volume to Vibrate To set the phone to Vibrate Mode, press the down Volume Control key until Ring Volume Vibrate is displayed.
2. Highlight Erase All and press [OK]. 3. Highlight Yes and press [OK]. Page/Text Message Storage Your LX360 can store up to 50 page/text messages. When the message memory is 100% full, a warning message prompts you to erase messages to obtain more memory space.
Roaming on to Other Service Providers Roaming occurs when you are in an area serviced by another authorized service provider. When this situation occurs, the R icon and Digital Roam of Analog Roam are displayed. If there is no service available, the ☎...
Selecting Ring Types for Voice Calls To Select a Ring Type for Voice Calls: 1. From the Main Menu, highlight Sounds and press [OK]. 2. Highlight Ring Type and press [OK]. 3. Highlight Voice Calls and press [OK]. 4. Highlight With Caller ID, No Caller ID or Roaming and press [OK]. Note: If you select Roaming, the Ring Type is used for all incoming roaming calls.
Tone Length Longer tone lengths may be better for tone recognition when dialing voicemail or other automated systems. To select a tone length: 1. From the Main Menu, highlight Sounds and press [OK]. 2. Highlight Tone Length and press [OK]. 3.
Display Menu Security Accessing the Security Menu You must enter your lock code to view the Security menu. If you forget your lock code, try using the last four digits of your Social Security number, the last four digits of your Phone Number or 0000. Security Menu To access the Security menu: 1.
Changing the Lock Code To change your lock code: 1. From the Security menu, highlight Change Lock and press [OK]. 2. Enter your new lock code. 3. Reenter your new lock code. Answering Your Phone with the Hands-Free Car Kit You can select different answering options when your phone is connected to the Hands-Free Car Kit.
Safety Guideline Provided herein is the TIA Safety Information for Wireless Handheld phones. Inclusion of this text in the terminal unit’s owner’s manual is required for CTIA Certification. TIA Safety Information Provided herein is the complete TIA Safety Information for Wireless Handheld phones. Inclusion of the text covering Pacemakers, Hearing Aids, and Other Medical Devices is required in the owner’s manual for CTIA Certification.
Page 32
In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones. Those guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies: ANSI C95.1 (1992) NCRP Report 86 (1986) ICNIRP (1996) Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature.
Page 33
DRIVING Check the laws and regulations on the use of wireless telephones in the areas where you drive. Always obey them. Also, if using your phone while driving, please: • Give full attention to driving -- driving safely is your first responsibility; •...
Page 34
Turn your phone OFF in health care facilities when any regulations posted in these areas instruct you to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy. Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles. Check with the manufacturer or its representative regarding your vehicle.
Page 35
An air bag inflates with great force. DO NOT place objects, including either installed or portable wireless equipment, in the area over the air bag or in the air bag deployment area. If in-vehicle wireless equipment is improperly installed and the air bag inflates, serious injury could result. Consumer Recycling Information and Logo Wireless…The New Recyclable Your wireless phone can be recycled.
FDA Consumer Update The U.S. Food and Drug Administration’s Center for Devices and Radiological Health Consumer Update on Mobile Phones 1. Do wireless phones pose a health hazard? The available scientific evidence does not show that any health problems are associated with using wireless phones. There is no proof, however, that wireless phones are absolutely safe.
Page 37
• Support needed research into possible biological effects of RF of the type emitted by wireless phones; • Design wireless phones in a way that minimizes any RF exposure to the user that is not necessary for device function; and •...
Page 38
3. What kinds of phones are the subject of this update? The term “wireless phone” refers here to hand-held wireless phones with built-in antennas, often called “cell,” “mobile,” or “PCS” phones. These types of wireless phones can expose the user to measurable radiofrequency energy (RF) because of the short distance between the phone and the user’s head.
Page 39
meningioma, or acoustic neuroma, tumors of the brain or salivary gland, leukemia, or other cancers. None of the studies demonstrated the existence of any harmful health effects from wireless phone RF exposures. However, none of the studies can answer questions about long-term exposures, since the average period of phone use in these studies was around three years.
Page 40
detailed agenda of research needs that has driven the establishment of new research programs around the world. The Project has also helped develop a series of public information documents on EMF issues. FDA and the Cellular Telecommunications & Internet Association (CTIA) have a formal Cooperative Research and Development Agreement (CRADA) to do research on wireless phone safety.
Page 41
8. What has FDA done to measure the radiofrequency energy coming from wireless phones ? The Institute of Electrical and Electronic Engineers (IEEE) is developing a technical standard for measuring the radiofrequency energy (RF) exposure from wireless phones and other wireless handsets with the participation and leadership of FDA scientists and engineers.
Page 42
Again, the scientific data do not demonstrate that wireless phones are harmful. But if you are concerned about the RF exposure from these products, you can use measures like those described above to reduce your RF exposure from wireless phone use. 10.
Page 43
FDA has tested hearing aids for interference from handheld wireless phones and helped develop a voluntary standard sponsored by the Institute of Electrical and Electronic Engineers (IEEE). This standard specifies test methods and performance requirements for hearing aids and wireless phones so that that no interference occurs when a person uses a “compatible”...
Consumer Information on SAR (Specific Absorption Rate) THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications ‘Commission of the U.S.
Page 45
Additional information about Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Association (CTIA) web-site at http://www.wow-com.com. ___________________________________________________________________________________ * In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue.
Need help?
Do you have a question about the LX360 and is the answer not in the manual?
Questions and answers