Sudaba Mini Soda Maker Manual

Trouble shooting
SUDABA
Can't pierce CO2 gas bombs
The original CO2 cartridge products of the SUDABA brand are not used;
The CO2 cartridge is not installed in place and not completely closed;
The head and pressure water botle are not tightened;
The host header is damaged (in
this
case, contact
SUDABA
customer
service
to
return the full set of products to SUDABA manufacturer for repair).
change your water
MINI SODA MAKER
Overflow during pumping
The pressure water bottle is too much water, exceeding the marked water level
line
The machine head and the pressure water bottle are not tightened in place;
Use more than one CO cartridge to hit the same bottle of water
The decompresslon is nol over, and the machine head is loosened too early.
MANUAL
Water cannot be carbonized or difficult to carbonize
The CO2 cartridge is not put into the nose, or the insertion method Is wrong:
The released (exhausted) CO2 cartridge is used again (the used CO2 cartridge
has
a
hole in
the piercing)
The water temperature used to make soda is not low enough (recommended
water temperature is 1 °C-6 °C).
Difficult or unable to load or remove CO2 cartridges
The CO2 gas bomb used is not compatible, please use the original brand CO2
cartridge of SUDABA;
The
cartridge
door
is
not fully
opened, and
the
door is
slid
upwards to fully
open;
The machine head is in contact with the pressure water bottle, and the COz
cartridge or the empty air bomb can only be loaded after the host header is
completely removed.
SUDABA
Service
SUDABA
Thank you for
purchasing
our
products, if you
have
any
questions
or find quality problems during use,You can contact us in the
following ways:
Changa your walr
Address:
Room 148,
Block
B,
First World
Plaza,
No. 7002,
Hung Hom West Road, Futian District, Shenzhen
Service Tel: 0755-83183268
SadaDream Technology (Shenzhen) Co. Ltd.