Programming and Downloading to Module ....9 NOTE: • Please read these instructions carefully and retain for future reference. • You will need a PC (Windows-based) to install all software. • Always power on the servos before beginning. www.HamiltonBuhl.com...
Master Control Board through coding. • battery and/ or USB power through a computer. c. OUTPUT MODULES (Color-Coded Yellow) Output Modules produce motion, audio and visual effects that include LED lights, LED light strip, buzzer, vibrator, voice recorder, servo and fans. www.HamiltonBuhl.com...
Page 4
The Tilt Switch attaches to an object to detect the tilt angle. Touch Sensor Module: The Touch Sensor activates a signal. IR Obstacle Sensor: The IR Obstacle Sensor detects when an object is within approximately 1 inch. Magnetic Sensor Module: www.HamiltonBuhl.com...
Page 5
Controls the Output Module, based on the following options, without any additional programming: • OFF – Acts as a power module only • NOT – Acts as a power module plus a NOT logic module • AND – Acts as a power module plus an AND logic module www.HamiltonBuhl.com...
Page 6
Record and playback up to 10 seconds of audio. Use the built-in microphone to record and mini-speaker to playback (connected by 3-pin plug). Use the REC and PLAY buttons to record and playback audio. Note: Use the Micro-USB cable as input and the 3-pin plug as output. www.HamiltonBuhl.com...
4.1 SOFTWARE INSTALLATION Follow these instructions to download and install the customized HamiltonBuhl’s Labplus Scratch Software. Go to: http://hamiltonbuhl.com/snips-software (for Operating Systems: Windows7/8/10.) to begin installation. From the pull-down menu, select your language to install and click “OK”. Select the destination location and click “Next”.
4.2 PROGRAMMING AND DOWNLOADING TO MODULE Setting Up Software • To launch the customized Scratch interface, double-click on the s folder). • Click on the Globe icon and select your language from the pull-down menu. www.HamiltonBuhl.com...
Page 10
• Click on the Help button and select “Install 210x USB Driver”. • Select “Next” • Select “I accept...” and click “Next” • Select “Finish” www.HamiltonBuhl.com...
Page 11
• Connect the Joint Module to the PC with the USB cable. • Click “Connect” in the bar menu and select the newly detected COM port,in this case is “COM6(newly detected)”. • Select the sample compiled program “Examples” and choose “Touch Light” www.HamiltonBuhl.com...
Page 12
• with a 9V battery when not connected with the USB. Product Registration Instructions Visit: www.HamiltonBuhl.com Click on Customer Care Click on Product Registration Form Please fill out all fields marked with * to register your product Warranty: Warranty begins the date item ships from our warehouse.