Download Print this page

PowerFilm AEM-CAPXX-PF-EVK Quick Start Manual

Solar development kit with e-peas pmic and cap-xx supercapacitors

AEM-CAPXX-PF-EVK Solar Development Kit with e-peas PMIC and CAP-XX Supercapacitors

Step 1: AEM10941 Configuration

MPPT Ratio:

Defined to 70%

Storage Element Voltages Protection:

BAL Option:

Select "CON" for dual-cells super capacitor and "GND" for any other storage.

PRIM Option:

Connect both jumpers "NoPRIM" or remove them if a primary battery is connected.

Define minimum voltage using R7 and R8.

LDOs Output Voltages:

Step 2:

Connect the storage element or solder a CAP-XX

super capacitor on the bottom layer (refer to the table on the following page)

Step 3:

Connect the Load(s) to HVOUT / LVOUT

Step 4:

Connect the PowerFilm Photovoltaic module to SRC

Step 5:

Set up complete! See User Guide for additional details and advanced configurations.

PowerFilm, Inc. • 1287 XE Place • Ames, IA 50014 USA • www.powerfilmsolar.com • 515-292-7606

Quick Start Guide

CFG2-CFG1-CFG0

ENHV [HVOUT] - ENLV [LVOUT]

5/22

Table of Contents

Need help?

Do you have a question about the AEM-CAPXX-PF-EVK and is the answer not in the manual?

Page 1 Connect the Load(s) to HVOUT / LVOUT Step 4: Connect the PowerFilm Photovoltaic module to SRC Step 5: Set up complete! See User Guide for additional details and advanced configurations. PowerFilm, Inc. • 1287 XE Place • Ames, IA 50014 USA • www.powerfilmsolar.com • 515-292-7606 5/22...
Page 2 Quick Start Guide AEM-CAPXX-PF-EVK Solar Development Kit with e-peas PMIC and CAP-XX Supercapacitors PowerFilm, Inc. • 1287 XE Place • Ames, IA 50014 USA • www.powerfilmsolar.com • 515-292-7606 5/22...