DAVID 0194A Assembly Instruction

STEP 1
MODEL : 0194A
DAVID DRESSER & MIRROR
Draw out mirror support (B) from the carton box.
(Box 1)
BOX OF MIRROR
Qty
NO ITEM
MIRROR
A 1 PC
MIRROR SUPPORT RAIL
B 2 PCS
(Box. 2)
BOX OF DRESSER
Qty
NO ITEM
DRESSER
C 1 PC
STEP 3 :
(Box. 1)
HARDWARE LIST
Qty
NO ITEM
JCBC BOLT M6 x 35MM BLK
8 PCS
1
SPRING WASHER 1/4" RBW
2 8 PCS
FLAT WASHER 1/4" ID x 19mmOD
BLK
3 8 PCS
ALLEN KEY m4 x 65mm BLK
4 1 PC
NOTE : MUST TIGHTEN SCREWS PERIODCALLY WITH USE SCREW WILL BECOME LOOSE CHECK TIGHTNESS OF ALL SCREW EVERY 6-8 WEEKS.
ASSEMBLY INSTRUCTION
ARROW MARKING - UP
B
A
Place mirror (A) on top of dresser (C). Align & fasten mirror support (B) to
the back of dresser (C) using long JCBC bolt (1) , spring washer (2) & flat
washer (3) THEN FULLY TIGHTEN ALL THE BOLTS AT STEP 2 & 3
WITH ALLEN KEY ( 4).
Note : Make sure arrow marking of the mirror support is
aligned with the arrow marking of the center of the
dresser as show in drawing.
STEP 2 : Align & fasten mirror support (B) to the back of mirror (A) using short JCBC
bolt(1),spring washer (2) & flat washer (3). DO NOT FULLY TIGHTEN AT THIS
STEP.
Note : Make sure arrow marking of the mirror support (B) is aligned up.
1
4
B
3
A
**BACK VIEW
B
A
C
1
3 2
4
ARROW MARKING - UP
COMPLETED ASSEMBLY