Kenwood PS-31 Instruction Manual page 9

5-4. FUSE REPLACEMENT
If the fuse blows, D I S C O N N E C T the A C Power Cable and
contact and authorized K E N W O O D service facility; either
your K E N W O O D dealer, or the factory to repair the cause.
NOTE:
T h e following instructions are for use by either your
K E N W O O D dealer, an authorized KENWOOD service facili-
ty, or the factory.
WARNING:
1. Never connect the A C cable to the A C outlet until fuse
replacement has been made.
2. Never use a fuse of higher rating. Replace with a new
fuse of the same rating.
If the fuse blows, check for the cause before replacing the
defective f u s e . (Replacement f u s e s are available from your
authorized K E N W O O D dealer.)
5-5. SUPPLY CORD REPLACEMENT
If the supply cord of this appliance is damaged, it must only
be replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required.
5-6. ORDERING SPARE PARTS
N O T E :
T h e following instructions are for use by either your
K E N W O O D dealer, an authorized K E N W O O D service facili-
ty, or the factory.
When ordering replacement or spare parts for the equip-
ment, be sure to specify the following:
Model and Serial Number.
Schematic Number of the part.
Printed Circuit Board Number on w h i c h the part is
located.
Part Number and Name, if k n o w n , and Quantity desired.
Part Numbers for most replacement parts are contained in
the Service Manual (usually available as an option from KEN-
W O O D dealer).
K E N W O O D C O R P O R A T I O N
K E N W O O D E L E C T R O N I C S A U S T R A L I A P T Y . LTD.
(INCORPORATED IN N S W )
4 E . Woodcock Place. Lane Cove, N.S.W. 2066, Australia
7