Cisco Multiband Wall-Mount Antenna AIR-ANTM5560P-R Specification Sheet page 11

Figure 6
1
1 Wall anchors
3 8-18 x 3/4-in. self-tapping Phillips screws
5
Molded antenna mount
To mount the antenna on a wall, follow these steps:
Step 1 Choose a location for mounting.
Step 2 If an extension coaxial cable is used, connect it to the access point and extend the coaxial cable to the
location for mounting the antenna.
Step 3 Attach the antenna to the molded antenna mount using the four provided 8-32 nylon lock nuts.
Step 4 Attach the antenna mount to the articulating arm (all mounting hardware is provided):
a. Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
Insert the screw and washers, first through the molded antenna mount, then the articulating arm.
b.
Secure the articulating arm to the molded antenna mount using a 1/4-20 hex nut.
c.
Find the molded wall mount and position it on the mounting surface. Use a pencil to mark the location
Step 5
of the mounting holes. There are four holes for wall-mounting, one in each corner.
Using a 3/16-in. (4.7 mm) drill bit, drill holes for the screws at the locations you marked in
Step 6
Route the cable either up or down from the wall or corner.
Step 7
Install a wall anchor in each hole.
Step 8
Line up the mounting holes on the molded wall mount with the pilot holes and start one of the provided
Step 9
8-18 x 3/4-in. self-tapping Phillips screws in each hole.
Tighten the screws with a Philips screwdriver.
Step 10
Attach the articulating arm to the molded wall mount (all hardware is provided):
Step 11
Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
a.
Insert the screw and washers, first through the molded wall mount, then the articulating arm.
b.
Secure the articulating arm to the molded wall mount using a 1/4-20 hex nut.
c.
OL-6847-01
Mounting the Antenna on a Wall
2
3
4
3
5
2 Molded wall mount
4 Articulating arm
Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)
Installation Instructions
Step 5.
11