Advertisement
If you wish to connect
hot and cold water
supply (Fig.1):
1. Fix the red marked inlet hose at the hot
water tap and at the inlet valve with the red
filter on the rear side of machine.
2. Fix the other inlet hose at the cold water
tap and at the inlet valve with the blue
filter on the rear side of the machine.
Make sure:
a) The connections are tightly fixed
b) Do not invert their position
(for example: cold fill into hot inlet valve
and viceversa).
HOT / COLD FILL INSTRUCTION
Fig.1
Do not allow children to operate, crawl on, near or inside your
washer.
Note that during wash cycles, the surface temperature of the
porthole door may increase.
Close supervision of children is necessary when the appliance is
used near children.
If you wish to connect only the cold
fill follow the below
instruction (Fig.2):
1. You need a Y-piece connector. The
2. Fix the Y-piece connector to the cold fill
3. Connect the two inlet valves present on
Make sure:
All connections are tightly fixed.
Fig.2
Y-piece connector can be ordered via our
Service Organization or purchased in a
specialized hydraulic component store.
tap.
the rear part of the machine to the Y-
piece connector using the relative
provider hoses.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 05442
Advertisement
