Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Inovance GA10-UPS12
- Page 1 GA10-UPS12 Uninterruptible (AC/DC 24 V) Power Supply User Guide Suzhou Inovance Technology Co,.Ltd Address: No.16, Youxiang Road, Yuexi Town, Wuzhong District, *19011672A00* Suzhou 215104, P.R. China Website: http://www.inovance.com 19011672 A00...
-
Page 2: Revision History
First-time Use For the users who use this product for the first time, read the manual carefully. If you have any problem concerning the functions and performance, contact technical support personnel of Inovance to ensure correct use. Revision History Date... - Page 3 4. Use this product according to the designated environment requirements. Damage caused by improper usage is not covered by warranty. 5. Inovance shall take no responsibility for any personal injuries or property damages caused by improper usage. ■ Safety Levels and Definitions DANGER : The "DANGER"...
- Page 4 CAUTION Do not use this product as a warning device that may cause serious personal injuries, ◆ equipment damages, or system shutdown. Use independent hardware and/or mechanical interlocks to design important alarm indications and the control/triggering equipment. During Installation WARNING Install this product correctly, and use this product indoors.
- Page 5 CAUTION To avoid electric shock, cut off the power supply of the product before connecting to the ◆ product. During Operation and Maintenance CAUTION Lithium batteries, LCD screens, and capacitors may contain ingredients that are harmful to ◆ health and environment. When disposing of the product, treat it as industrial waste. ☞...
-
Page 6: Product Information
1 Product Information 1.1 Appearance and Model ■ Appearance ■ Model 1.2 Basic Parameters Item Description AC Input Input voltage 220 VAC (100 VAC to 240 VAC) AC frequency 50 Hz to 60 Hz Maximum input current 3 A/110 VAC; 1.5 A/220 VAC Input surge current <... - Page 7 Item Description Rated output voltage 24 VDC Output voltage ripple < 80 mVp-p Load regulation rate < ±2% Source regulation rate < ±0.5% Rated output current 4.0 A Output short circuit Output is automatically cut off upon short circuit, and output protection resumes after short circuit is rectified.
-
Page 8: Mounting Dimensions
Item Description Green, flashing once every 2s: Charging Charging/ Green, steady on: Charging is completed. CHARGE discharging Green, flashing once every 0.5s: The input power supply fails. indication The UPS provides the power supply (3s/4 A). Red, steady on: The UPS is faulty due to output short circuit, UPS fault overload, or input overvoltage. - Page 9 Figure 2-1 Mounting dimensions (mm)
-
Page 10: Mounting Mode
2.2 Mounting Mode 1） Hang the upper fixing jaws of the product to the upper part of the DIN guide rail by following direction A. Then, hard press the product by following direction B until the middle and side fixing jaws are aligned. 2）... -
Page 11: Terminal Description
3 Electrical Design Reference ■ Terminal description E Series Tube-Type Wiring Diagram Signal Type Cable Terminal Specification AC input terminal 18AWG E1008 DC output terminal (24 18AWG E1008 V output) DC output terminal 18AWG to E1008/E7508/E0508 (signal output) 24AWG ■ Wiring diagram... - Page 12 ■ Tube-type wiring terminal specification Dφ Cφ...
- Page 13 Cross Dimension Sectional Model Area Dφ Cφ (mm²) E0506 12.0 E0508 14.0 E0510 10.0 16.0 E7506 12.4 E7508 14.6 0.75 E7510 10.0 16.4 E7512 12.0 18.4 E1006 12.4 E1008 14.6 E1010 10.0 16.4 E1012 12.0 18.4 ■ Connecting to the AC800 series controller...
- Page 14 The startup signal and power-off detection signal AC OK terminals must be connected according to the preceding figure. For other state signal terminals, connect them as required. ■ Connecting to the AP700 series controller...
- Page 15 The startup signal and power-off detection signal AC_OK terminals must be connected according to the preceding figure. For other state signal terminals, connect them as required.
-
Page 16: Warranty Agreement
4） Operations not following the user instructions 5） Damage out of the equipment (for example, external device factors) If there is any problem during the service, contact Inovance’ s agent or Inovance directly. The maintenance fee is charged according to the latest Maintenance Price List of Inovance.
Need help?
Do you have a question about the GA10-UPS12 and is the answer not in the manual?
Questions and answers