Advertisement
Available languages
Available languages
1.
Please be sure that the batteries in the microphones are charged and if necessary
replace them. To open the battery case, take the handmic and rotate the lower part
(20) clockwise by unscrewing it. If you use bodypack transmitters just open the small
cover (14). Remember to plug the jack into the jack 3,5mm microphone's socket (17).
Important: use only compatible batteries (2 x AA 1.5V) and do not dispose of the
replaced batteries with normal household waste, but rather hand them over to a
special collection point.
2.
Position correctly the receiving base, by keeping a distance of at least 1 mt from
the floor or walls. Connect it to mixers or amplifiers through the balanced XRL
socket (11) or through the mixed socket with unbalanced Jack 6,3 mm (10) signal.
The models with single transmitter have only one XLR output.The output signal
is of microphone type. Make sure that the antennas (8-13) are raised in vertical
position.
3.
Connect the adaptor to the back socket (9) and then to the 230V domestic
power source. Warning: don't connect the adaptor to the power socket before
connecting the jack: this could cause a spark and damage the unit.
4.
After turning on the other components of your audio system, press the
ON/OFF key (7) on the base. The led (6) will light on. Press then the ON/
OFF key (16-19) on the transmitter. The led (15-18) will indicate the
batteries' charge stauts. If it is red it will necessary to replace the batteries.
5.
If you are using a bodypack transmitter the clip on the back will allow you to hook
it to your belt to carry it easily.
6.
Adjust as you wish the receiver's volume through the controls (3-5) on the
base. There are double controls to manage separately the two wireless
microphones. The displays show information on the signals received by the
microphones. The single microphone models have just one volume control.
7.
In order to work correctly, transmitter and receiver must operate on the same
frequency. In case of malfunctioning check that base and microphone have the
same frequency (you can find the frequency in the battery case).
8
Before arranging any connection make sure that the product
is unplugged from the mains. All connections must be
made with the device off.
Advertisement
