Summary of Contents for Comtrend Corporation VI-3234u
Page 1
ANGLOPACK Quick Setup Guide Comtrend VI-3234u modem This version is for "dégroupage total", i.e., no more analogue landline rental Required configuration - Pre-existing landline, non-shared analogue (which will be disconnected in the process) - Classic or DECT landline telephone - Computer with the following specifications: •...
Page 2
RJ11 male/male connectors, 2m, green or gray Male plug / RJ11 female, Beige RJ45 male/male connector, 2m, yellow 1 x female French telephone adapter 1 x Wi-Fi Modem Router Electrical power supply and cable female plug adapter / RJ11 male Comtrend VI-3234u 220V power supply...
Page 3
Installation 1/ Configure your computer network 2/ Connect your equipment & phone As described on the 'Connexion Map' page • The Internet Protocol properties should be set to: • Due to auto configuration mode, the modem may self-reboot, so please wait until •...
Page 4
Connection map This version is for "dégroupage total", i.e., no more analogue landline rental YOUR COMPUTER Yellow RJ45 Green RJ11 male/male cable male/male cable Main (Ethernet) telephone socket ADSL Cable and MODEM Connect your computer on power supply any of the LAN plugs with the yellow cable.
Page 5
Wi-Fi configuration (optional) For more convenience the Wi-Fi interface of 2/ Enable/Disable Wireless your modem is enabled. But you can choose to The following screen displays. Tick the 'Enable Wireless' check • box as wanted, then Apply/save. enable/disable it as wanted. See below. 1/ Access the modem configuration interface In order to do so, open Internet Explorer •...
Page 6
What to do in the event of a problem? Event Test procedure or possible cause Check that the power supply block is properly plugged in. The POWER LED is not lit Check that the power supply cable is properly connected to your terminal. Check that the electrical socket is working correctly and that your electrical supply is on (power cut ).
Need help?
Do you have a question about the VI-3234u and is the answer not in the manual?
Questions and answers