SANYU SSXA Series User Manual page 23

SANYU
This protection function will put into work as soon as the instant current is
running
big. The default value is 200%. It means the protection value is twice as the rate
current
current。
protection
There are two stop modes: soft stop and free stop. The default value is 1-free
Stop mode
stop. The soft stop function is aimed at "water hammer". The free stop is set as
normal. For detail see chapter 6.4。
This parameter is valid only when the stopping mode is free stop. It decide the
Soft stop
time and effect of the soft stop. The smooth stop effect will be gained if this
factor
parameter is set correct
Running
This parameter control if the running over-current protect is on.
current
1：ON；2：OFF
protect
Current
This parameter control if the current unbalance protect is on.
unbalance
1：ON；2：OFF
protect
Programmable Which state can be output through the programmable relay
relay output 0:null，1:starting，2:bypass，3:running，4:soft stop，5:fault.
select
Communicate
MODBUS Communicate Address： 1～256
Address
Baud Rate
MODBUS Communicate Baud Rate（0:2400；1:4800；2:9600；3:14400；4:19200；5:28800）
Soft starter SSXB/SSXA serie User Manual
23