Download Print this page

John Lewis Boris Instruction Manual page 3

Toddler bed

Step 1

Part A

Note hole toward

headboard

Push four barrel nuts (fixing 3) into the holes in the base sides (part E) as shown above.

Make sure that the slots are visible and, if necessary, use a flat-headed screwdriver to ensure that the

slots point towards the holes in the ends as shown. Insert a wooden dowel (fixing 4) into each of the

upper and lower holes in the base sides. Attach the headboard (part A) and footboard (part B) using

four long bolts (fixing 1).

Step 2

Part C

Lay the base slats (part E) on the ledge on the inside of the base sides so that the end slat is level with

the end of the ledge as shown. Secure this slat to the base sides using two of the base screws (fixing 5).

Move the other end slat toward the footboard as far as the fabric straps will allow and secure this with

two more base screws (fixing 5). Finally, secure the two centre slats using four base screws (fixing 5).

Once the base slats have been fitted, they should not be removed.

4 x Fixing 3

Part E

8 x Fixing 4

8 x Fixing 5 (4 on each side)

(Do not fully tighten bolts at this stage)

4 x Fixing 1

Part B