Parts List - Heath HEATHKIT HA8-8 Manual

Unpack the kit and check each part against the follow­
ing list. The key numbers correspond to the numbers
on the "Parts Pictorial". Return any part that is
packed in an individual envelope, with the part
number on it, to the envelope after you identify it
until that part is called for in a step. Do not discard
any packing material until all parts are accounted for.
KEY HEATH QTY. DESCRIPTION
No. Part No.___________________ Comp. No.
RESISTORS—CAPACITORS
NOTE: The following resistors are rated at 1 /4-watt and have a
tolerance of 5%. 5% is indicated by a gold fourth color band.
A1 6-221-12 2 220 fl (red-red-brn)
resistor
A1 6-102-12 11 1000 fl (brn-blk-red)
resistor
B1 21-761 3 .01 p.F ceramic capacitor
2.2 /
B2 25-221 2
INTEGRATED CIRCUITS
NOTE: Integrated circuits are marked for identification in one
of the following four ways:
1. Part number.
2. Type number. (This refers only to the numbers; the
letters may be different or missing.)
3. Part number and type number.
4. Part number and a type number other than the one
listed.
C1
443-755 1 74LS04
C1 443-732 1 74LS30
C1 443-77 1 7438
C1 74LS74
443-730 1
C1 74LS240
443-754 1
C2
442-54 1 7805
CAUTION: The following IC can be damaged by static electric­
ity. Do not remove this IC from the conductive foam until you
are instructed to do so in a step.
C1 444-70* 1 ROM
* NOTE: Your integrated circuit may be marked 444-74. Either integrated circuit
will work properly.

PARTS LIST

CIRCUIT
R1, R2,
R3, R4,
R5, R6,
R7, R8,
R9, R11,
R12, R13,
R14
C1, C2,
C5
.F tantalum capacitor C3, C4
j
U4
U5
U6
U3
U2
U1
IC204
To order a replacement part, always include the Part
Number and use the Parts Order Form furnished with
this kit. If a Parts Order Form is not available, use one
of the "Expedited Parts Order Forms" at the rear of
this Manual, or refer to "Replacement Parts" inside
the rear cover. Your Warranty is located inside the
front cover. For prices, refer to the separate "Heath
Parts Price List."
QTY. DESCRIPTION
KEY HEATH
No. Part No.
CONNECTORS—SOCKETS
D1 432-865 1 3-connector shell
D2 432-866 4 Spring connector (3 extra)
D3 432-946 1 25-pin plug
D4 432-986 1 3-pin plug
D5 432-1125 2 26-pin socket**
D6 434-298 4 14-pin IC socket
D7 434-311 1 20-pin IC socket
MISCELLANEOUS
E1 60-621 1 8-section slide switch
85-2521-1 1 Circuit board
E2 261-29 2 Square foot
340-8 12" Bare wire
344-55 6" Green wire
344-92 12" Red wire
E3 438-55 2 Polarizing plug
E4 Blue and white label
E5 490-185 1 Desoldering braid
1 Manual (See Page 1
for part number.)
1 ROM (listing)
Solder
**NOTE: You may have been supplied two 6-pin and two 20-pin sockets instead
of two 26-pin sockets.
CIRCUIT
Comp. No.
SW1