Advertisement
Quick Links
User Manual of ESL Access Point 3.0
1. Product parameters
Item
Type
Structure size
Weight
Appearance color
Operating voltage
Operating current
Communication Mode
Communication distance
Data Interface
Storage temperature range
Humidity
2. Product introduction
Upside
Status indicator: Working status indication (R / Y / B)
LED_ R: Power indicator
LED_ Y: Work indicator
LED_ B: Work indicator
Indicator nixie tube: Working status indication and Access Point number indication
H: Idle
C: Busy
----: Offline
Parameter value
ETAP03
190mm(H)×190mm(V)×39mm(D)
285g
white
DC 5V
less than 200mA
2.4G
20-50 meters
Standard network cable interface
-20℃~70℃
45%~70%RH
Note
Please use the original
power supply
Advertisement
Summary of Contents for ESL ETAP03
- Page 1 User Manual of ESL Access Point 3.0 1. Product parameters Item Parameter value Note Type ETAP03 Structure size 190mm(H)×190mm(V)×39mm(D) Weight 285g Appearance color white Please use the original Operating voltage DC 5V power supply Operating current less than 200mA Communication Mode 2.4G...
- Page 2 Backside Power interface: DC 5V standard power supply Power indication: The two lights are always on, indicating that the power supply of the Access Point is normal. Debug interface: The one close to the power supply port, DO NOT USE. Data interface: The one far away from the network port, UTP / STP of category 5 or above shall be used.
-
Page 3: Configuration Description
3. Configuration description Hardware environment setup The initial configuration requires power supply to the Access Point and direct connection to the local computer through network cable. Connection mode The power adapter -> the Access Point power port b. The Access Point data port -> the computer network port by network cable. Network environment settings 1.IP address configuration Default IP address of Access Point... - Page 4 Default IP configuration modification If you need to modify the default IP configuration of the Access Point, you need to do the following. 1. Open the Access Point configuration tool [AP config tool], confirm that the Access Point is online [Online], and click "Read"...
-
Page 5: Communication Mode
2. Modify the current configuration information as needed, as described below. After modification, click "Apply" button to complete the update. Configuration item Default value Configuration description In the same network environment, the Access Point ID Access Point ID needs to be accumulated according to the number of Access Points, such as 01, 02, etc. -
Page 6: Fcc Statement
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the ETAP03 and is the answer not in the manual?
Questions and answers