Table of Contents
Advertisement
If you install the scanner between two other external SCSI devices
1
Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, see
2
Disconnect your SCSI cable from one of these two SCSI devices.
3
Connect the free end of this SCSI cable to the scanner.
4
Connect the 50-pin end of the SCSI cable (the one supplied with your scanner) to the other
adjacent SCSI device.
5
Snap the diamond shaped wire clips into the clip brackets to secure the connection.
6
Connect the 25-pin end of the SCSI cable (the one supplied with your scanner) to the scanner.
7
Tighten the connector screws to secure the connection.
8
Make sure that the last device in the chain is terminated.
Choosing a SCSI ID
Number.
Chapter 2: Installing the Scanner
29
Hide quick links:
Advertisement
Table of Contents
