Table of Contents
Advertisement
Roll Over Sensor
The rollover sensor is installed in the rear behind the right rear seat back on the rollover cas-
sette. It contains the processing electronics for rollover detection and deployment final
stage for triggering the rollover bar solenoids. Two capacitors are also installed for roll bar
deployment in the event of a power failure with the system during an a crash. The sensor
is connected to the diagnostic link for troubleshooting purposes.
The sensor preforms a self check every time the ignition is switched on. If any faults are
detected, the warning lamp in the cluster will illuminate. If possible, the system will trigger
the solenoids even though a fault is stored in the fault memory.
ART-ROLLOVERSENSOR
ART-ROLLOVERSEN1
44
E46iCCVM/ST039/3/21/00
Advertisement
Table of Contents
