Jones FlexRx Filling Instructions

™
FlexRx Light Adherence Packaging
FILLING INSTRUCTIONS
Place the blister in the assembly tray with the longer, top flange directed toward
the top of the tray where the pins are located. (1)
Fill the blister with medication for each appropriate time pass as indicated on the
patient label. (2)
Snap the edge ties on either side of the label, as indicated on the backside
of the label. (3)
Locate the perforation on the back of the label and fold along this perforation,
so the top part of the label meets the bottom part of the label. (4)
Remove the strip on the back of the label where indicated to expose a line
of adhesive. (5).
Orient the label with the coloured side facing up and
the folded edge at the top. Centre the label over the
blister (6a), aligning the folded edge with the perforation
line at the top of the blister. (6b)
With the folded edge of the label closely aligned to the
perforation on the blister, steady the positioning of the
label in the middle of the tray with one hand, and then
use the other hand to fold back the top part of the label
toward the tray (7a). Firmly run your finger over
the adhesive strip area on the label against the top flange
of the blister to ensure adhesion. (7b)
+1.519.659.8373
t:
+1.800.265.1009
tf:
+1.519.659.8306
f:
JonesHealthcareGroup.com
3000 Page St. London, ON, Canada N5V 5H3
1
2
3
4
5
6a 6b
7a 7b