Advertisement
Quick Links
Advertisement
Related Manuals for Midtronics MSP-070-5
Summary of Contents for Midtronics MSP-070-5
- Page 1 October 2017 167-000757EN-A MSP-070C 70A Battery Maintainer USER GUIDE...
-
Page 2: Table Of Contents
MSP-070C Battery Maintainer Contents Safety Guidelines General Safety Precautions Personal Precautions Preparing To Charge The Battery Grounding & Power Cord Connections Charger Location DC Connection Precautions Installing The Battery Removing the Battery Maintenance & Storage Locking Power Cord Wireless Safety Connections &... -
Page 3: Safety Guidelines
Safety Guidelines MSP-070C Battery Maintainer Safety Guidelines Personal Precautions For safe, efficient, and accurate charging and testing, review the safety and operating instructions in this manual before using the 2.1 The MSP-series chargers are not to be used by people with re- analyzer. -
Page 4: Grounding & Power Cord Connections
Safety Guidelines MSP-070C Battery Maintainer Charger Location 3.4 For flooded cell batteries, add distilled water in each cell until the battery acid reaches the level specified by the manufacturer. Not for permanent installation: Modifying this charger for permanent This helps purge excessive gas from the cells. Do not overfill. For installation in a vehicle or installing this charger in a vehicle for a battery without caps, carefully follow the manufacturer’s re- permanent use is not recommended. -
Page 5: Installing The Battery
Safety Guidelines MSP-070C Battery Maintainer Installing The Battery Maintenance & Storage Follow these guidelines to protect the charger and test cables from damage and premature wear: 9.1 The grease, dirt, and sulfation that build up on battery terminals Risk of explosive gases. are highly corrosive and can damage the clamps over time. -
Page 6: Connections & Controls
Connections & Controls Locking Power Cord The Midtronics MSP-070C converts 120-240 volts nominal AC to a selectable (14.4 VDC, 13.6 VDC, or 13.2 VDC) voltage for use Always use the red tabs on each side of the power cord connector to as a power supply. -
Page 7: Product Specifications
Connections & Controls MSP-070C Battery Maintainer Product Specifications Protection Features Operating Parameters • • Reverse polarity Battery voltage too low (<5.5V) Input Voltage 110V – 240V~, 50 – 60 Hz, 12A max. • • Non-12V battery Clamp high temperature Output 1 14.4VDC max., 70A max.