Talkaphone VOIP-600 Series Configuration And Operation Manual page 57

Hide thumbs Also See for VOIP-600 Series:

Table of Contents

Select the Upgrade check box.

Click Apply. One of the following progress messages is displayed:



Firmware upgrade initiated. Do not reboot...: The firmware upgrade has been initiated; the

firmware upgrade request is processed only when phone is in an idle state. For example, a call is in

progress and administrator requests for a firmware upgrade through the Web GUI. The phone checks

for an active call every five seconds and starts the process once the active call is terminated.

The following are considered to be idle phone states: no active call, no dialing, no voice message is

being played, and the Auxiliary Output is deactivated.

Firmware upgrade in progress. Do not reboot...: The firmware upgrade is in progress. The process



generally takes around 1-2 min to complete.

Firmware upgrade done. Going to reboot...: The firmware upgrade is complete and a reboot has



been initiated. After approximately one minute, the phone will be accessible once again.

4.11.7.

SMTP Server Configuration

The SMTP Server Configuration page is used to configure the mail settings for email notifications.

To setup SMTP:

Check the Enable SMTP check box.

Enter the SMTP Address and Port where emails should be sent.

Click Apply to save settings.

Note: VOIP-600 does not support 'Authentication with the mail server'. Hence, if it is desired that an e-mail be

sent out via such a Mail Server which requires authentication, a 'Mail Relay' will have to be configured to achieve

this and it's IP address should be put in the 'SMTP Address'.

Page 57 of 94

Configuration / Operation Manual

Figure 29 SMTP Server Configuration

VOIP-600 Series Phone

Rev. 9/17/2014

Table of Contents

Voip-600e