KMART SLR-17133 Assembly Instructions

SLR-17133

IMPORTANT SAFETY INSTRUCTIONS:

The following safety precautions should always be followed, to reduce the risk of electric shock, personal injury or fire. It is
important to read all of these instructions carefully before using the product, and to save them for future reference or new
users.
1. This product must only be used as intended in accordance with the enclosed operating instructions.
2. Do not carry the appliance by the mains cable or pull the cable to remove the plug from the socket.
3. CAUTION: Electric shock hazard. The external flexible cable, plug or the switch of this luminaire cannot be replaced. If any of
these parts are damaged, disconnect from mains power. The luminaire should be destroyed!
4. If the appliance stops unexpectedly or appears to malfunction, switch off the power supply, unplug from the mains and stop using
immediately. Seek professional advice to rectify the fault or make repairs.
5. Switch off the power supply or unplug from the mains socket when not in use, before cleaning or changing accessories.
6. Avoid positioning the appliance where the power cable might be accidentally trapped or damaged.
7. Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.
8. Ensure the appliance is switched OFF before connecting the mains power supply.
9. Be aware that some surfaces may become hot. Do not touch hot surfaces and supervise others accordingly.
10. This product has not been designed for use by children.
11. Children should be closely supervised at all times when they are near any electrical appliance.
12. To protect against electric shock, never allow the appliance, the mains cable or plug to come into contact with water or any other
liquid.
13. Never reach for any appliance that has fallen into water. Switch off the power supply at the mains immediately and unplug. Do
not re-use until the product has been inspected and approved by a qualified electrician.
14. Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and mains supply
connections.
15. To disconnect, first ensure that all controls are in the OFF position, then remove the plug from the electricity supply.
16. Where relevant keep all ventilation slots, filters, etc. uncovered and clear of debris. Never drop or insert objects into the openings.
17. Do not use outdoors. This appliance has been designed for domestic indoors use only.
ADAPTOR (Use the provided adaptor model no.:
INPUT: 100-240V ~ 50/60 Hz Max. 0.3A
OUTPUT: 12V DC 500mA
Lamps: Max. 6W
Neon lamp
Tubes length: 1.15m
Linear length: >1mm
Type of gas mixture: Neon
Max: 106mA
OUTPUT: 12V 500mA

INSTRUCTIONS FOR ASSEMBLY

1. Insert the neon tube into the base.
2. Using a screwdriver tighten the screw into the base.
. 3 . Insert the adaptor plug into the socket.
4. Connect to the mains supply and switch on.
5. CAUTION: Glass Tube, Handle with Care.
6. To prevent damage do not touch the glass tube.
Warning: Each neon light style has a unique neon tube and base combination,
please use original matching base with correct neon tube. Non-suitable
for installation within the arm's reach and the tube should be fixed on
the base by screw.
The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced
CACTUS NEON LIGHT
LY06-120-0500A)
J?
DC3.5
C3
472
R
S1
SW-SPST +12 2K
+C1
470uF/25V
Q1
D882
D1
4007
T?
C4
TRANS4
10P
C2
D2
473
4007