GSL electronics KBI-100A-12V Operating Instructions

Model:
KBI -100A -12V
Page 1 of 1
Warning: Before commencing work ensure that the negative terminals from the main and auxiliary
batteries have been disconnected.
Wiring Instructions
1. Mount the isolator high up in the engine bay away from moisture and any source
of external heat and
2. Scratch away the paint from the body surface and earth the black wire onto the
body.3. Connect the main battery terminal of the solenoid to the positive terminal of the
main battery using 6B&S cable.
4. Connect the auxiliary battery terminal of the solenoid to the positive terminal of the auxiliary battery using
6B&S cable.
5. Ensure that the auxiliary battery is correctly earthed using a minimum 3B&S cable.
6. (Optional) Connect the blue wire to Auxillary Battery Positive via a momentary switch for manual override. If
you do not use this option, ensure that it is secured away from ground or + voltage.
7. (Optional) Connect the green wire to positive of supplied LED.
L.E.D Codes :-
ON: Solenoid contacts closed, normal operation.
OFF: Solenoid contacts open, normal operation.
Flashing : Abnormal Operating conditions. These are as follows: Low Main Battery (
(Above 15.1V), Solenoid Coil Shorted (Latched alarm/ requires disconnection of solenoid to clear), Excessive Solenoid Drop (
Latched alarm/requires disconection to reset) . In all cases when flashing occurs check both batteries and charging system for
faults.
Warranty Conditions: Our products come with guarantees that cannot be excluded under the Australian Consumer Law.
The customer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
The customer is also entitled to have the products repaired or replaced if the products fail to be of acceptable quality and the failure does not
amount to a major failure.
Intelligent Battery Isolator
Please read these instructions before use
sources. e.g Fuel Lines, Exhaust systems.
Operating Instructions
Max Current
Cut In Volt
Cut Out Volt
Below 9.5V), High Main Battery
100 A
13.2 V ±1%
12.7 V ±1%