Advertisement
www.starling-tech.com
Instruction Manual
Warning : Protect Board from electrostatic discharge. Ground yourself before handling.
Protect bottom of board from shorting against anything metal.
Photo1. Receiver board with antenna and sync button.
Optional RC units for our products must be installed before shipping, they cannot be installed by
some time in the future by the client. Micro chip programming is different between RC and non-RC
products.
RC Transmitter:
Advertisement
Table of Contents
Summary of Contents for Starling Technologies E/FX
- Page 1 www.starling-tech.com Instruction Manual Warning : Protect Board from electrostatic discharge. Ground yourself before handling. Protect bottom of board from shorting against anything metal. Photo1. Receiver board with antenna and sync button. Optional RC units for our products must be installed before shipping, they cannot be installed by some time in the future by the client.
- Page 2 The Transmitter button may be accessed by sliding the door on front of unit to expose button. Antenna on unit may be extended. Transmitter contains a small 12v alkaline battery. Remove the three screws from the back and carefully separate the two halves, replace battery. If the tiny screws wont tighten for you, add a little white glue to each hole, assemble and insert screws.
- Page 3 You should now be synced, test your kit. Thank you again for purchasing the kit from Starling, E/FX™ Stanley J. Koziol All photos contained in this document are property of Starling technologies™. This document may not be copied, sold or transfered without permission. ™ ™ E/FX is a trademark of Starling Technologies Copyright ©...
Need help?
Do you have a question about the E/FX and is the answer not in the manual?
Questions and answers