Page 1
QK-R041 Manual QK-R041 Manual WIRELESS 4G LTE ROUTER Features Stable and Reliable Industrial design, metal enclosure, with waterproof IP30 rating ◼ Wide input voltage range: DC 9-36V, with reverse polarity protection ◼ ESD, Surge, EFT/Burst protection ◼ Multi-types of VPN and firewall against network attacks ◼...
Limited Warranty and Notices ......................15 Glossary ............................16 1. Introduction The QK-R041 is a marine wireless router designed for permanent installation on boats and yachts. It provides Internet connection for devices connected to it through WiFi and Ethernet cables via 4G/3G V 1.0...
The R041 features two MIMO 4G diversity antennas which ensure excellent mobile network reception and two omni-WiFi antennas which offer great WiFi signal strength onboard. The QK-R041’s WiFi network is secure, and password protected and allows for up to 32 devices to be connected to the router at the same time.
QK-R041 Manual The R041 wireless marine 4G router multiplexer has the following options for inputs, outputs and host devices. • Power supply • 1x 4G SIM card slot • 2x digital inputs and 2x digital outputs • 1x RS232 interface, supports NMEA 0183 protocol •...
QK-R041 Manual When inserting a SIM card, ensure the SIM card has the correct orientation. Do NOT insert the SIM card at an angle or use force. There is also an SD card slot next to the SIM card slot, the use of this is not currently supported by the firmware.
QK-R041 Manual used for switching, rather than driving other inputs. 3.5.1. Digital inputs DI1 and DI2 are two digital inputs. Digital Inputs allow the R041 to detect logic states (low or high) when GND is connected to or disconnected from the DI1/2 terminals of the router. Using the R041’s configuration interface, the operator can set up the input parameters and specify what actions should be executed when the digital input is triggered.
QK-R041 Manual 3.6. RS232 serial interface (NMEA 0183) The R041 features an industrial RS232 serial interface. It supports up to 230.4kbps baud rate. Since the most marine NMEA 0183 devices support the RS232 or RS485 communication protocols, the R041 can communicate with these devices through its RS232 interface.
QK-R041 Manual Figure 4 The antenna connections 4. Indication LEDs The R041 features indicator LEDs which show power, system, WiFi and 4G/3G network strength status. There is also another LED on the front panel, which can be customized as required by the operator.
Page 10
QK-R041 Manual 2. Launch a web browser on the device connected to the router, and input 192.168.1.1 into the address bar and click enter. 3. You will be asked the login in ID and password, both of which are ‘admin’.
Page 11
QK-R041 Manual The above image shows the main status page of the router. On the left side of the page, it’s the main menu bar, which will take you to various status, configuration, tools, and service menus. The default R041 settings have been carefully selected to work well in most situations/installations, commonly found on pleasure boats.
Page 12
QK-R041 Manual Once the setup has been completed, click ‘Save & Apply’ and wait for a couple of minutes to see the network LED turn on. For some SIM cards, you probably need to re-power the R041 to activate the new settings. Please contact your data SIM provider if more information or further details needed.
QK-R041 Manual The SSID name and the password can be changed in ‘General Settings’. Please, don’t change any settings in ‘Advanced Settings’ unless you know exactly how the changes will affect the functionality of the router. 6. Upgrading software Before updating the router’s firmware, please switch off all the devices connected via the digital input / output and the RS232 ports.
QK-R041 Manual Wait for about 5 minutes until the status LED starts flashing once every second Firmware update is done, you can start using your device now. 7. Specification Item Specification DC supply 9V-35V Average supply current 525mA @ 12V...
Quark-elec warrants this product to be free from defects in materials and manufacture for one year from the date of purchase. Quark-elec will, at its sole option, repair or replace any components that fail in normal use. Such repairs or replacement will be made at no charge to the customer for parts and labour.
QK-R041 Manual 9. Glossary • Ad-hoc WiFi, also known as ‘peer-to-peer’: devices communicate directly with each other without a router. • IP: internet protocol (ipv4, ipv6)- explains which version • IP Address: is a numerical label assigned to each device connected to a computer network.