Summary of Contents for EVERLAST CLIMBING Tyke Tower
Page 2
Table of Contents Tyke Tower™ Safety, Care and Maintenance Instructions Products protected by US Patent #7056266 Climbing Wall Care and Maintenance Instructions Notification Letter/Permission to Participate Tyke Tower™ Rules and Supervisor Guidelines Warnings Assembly & Installation Instructions Tyke Tower™ Assembly Instructions Groperz™...
Page 3
Climbing Wall Care and Maintenance Instructions ** Please read carefully before assembling and using products ** The proper care and maintenance of your climbing wall is essential and is your responsibil- ity. Inspect your climbing wall, it’s components and protective surfacing on a regular basis. These inspections should include, but are not limited to, the lists that follow.
Page 4
Outdoor Climbing Walls Surface Panels should be installed according to Installation Instructions. Never use climbing wall when it is wet. Check panels to make sure they are in good condition and show no signs of stress. Check each panel’s adherence to the wall/mounting posts. Tighten only when they are loose.
Page 5
We recommend that you send home a notification letter and receive permission for students to participate prior to use of your Tyke Tower™. Below is a sample for you to modify to suit your needs. (Contact us at 800.476.7366 for a Spanish version of this letter).
Page 6
Step away from the mat. Supervisor Guidelines: Climbers should be supervised at all times. Climbers should be traveling horizontally around the Tyke Tower, not over or into it. Regularly inspect wall, its components and protective surfacing to ensure they are in good condition.
Page 8
Back of panel Camlock Fastener (Tongue) Bottom THE PROPER CARE AND ONGOING MAINTENANCE OF YOUR CLIMBING WALL IS ESSENTIAL AND IS YOUR RESPONSIBILITY. PLEASE REFER TO THE SAFETY, CARE AND MAINTENANCE INSTRUCTIONS. WARNING MANUFACTURED BY: EVERLAST CLIMBING INDUSTRIES, INC 800.476.7366 4/23/09...
Page 9
INSTALLATION INSTRUCTIONS: (Please read all instructions thoroughly before starting to install) 1). Begin by joining two sides of the Tyke Tower™. Push the tongue side of one panel into the groove side of another. Lock the panels together using the 5/16” T-handle wrench to lock the camlock fasteners.
Need help?
Do you have a question about the Tyke Tower and is the answer not in the manual?
Questions and answers