Advertisement
CONSUMPTION DATA
Programme
Temperature
selector
(°C)
Cotton
90
Cotton
60
Cotton + Half Load
60
Cotton short
40
Synthetic
60
Synthetic short
40
Delicate
30
Wool
40
Silk
30
Prewash cycle increases programme duration by approx. 15 min. Consumption values were measured in normalized
conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Add the detergent and the additives into the dispenser as
follows:
•
Programme with pre and main wash
•
Main wash programme without prewash
•
Fabric softeners and conditioners
•
Stain remover agents
•
Anti-scale agents (water hardness 4)
Important:
•
Be careful not to fill more than the "MAX" level mark.
•
For programme with prewash: do not use liquid detergents.
•
For programmes without prewash from cold to 40° C, it is
recommended to use a liquid detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
1.
Turn the programme selector knob clockwise to the desired programme.
2.
Turn the temperature knob to the required temperature.
3.
Turn the spin speed selector to the required setting.
PRESS THE DESIRED SPECIAL OPTION BUTTON(S)
"Rinse Hold" button
•
The laundry remains in the last rinse water without progressing to the spin cycle to avoid
creasing and prevent colours from changing.
•
This option is particularly recommended for the programmes "Synthetic" or "Delicate".
•
This function is particularly useful if you want to postpone spinning to a later time or when
you do not wish to spin the clothes.
Note: The programme selector knob stops on the position "
Load
Water
Energy
Programme
Duration
(kg)
(l)
(kWh)
(min)
5.0
71
1.90
120
5.0
55
0.95
120
2.5
35
0.95
95
5.0
55
0.60
70
2.0
57
0.80
90
2.0
49
0.40
50
1.5
50
0.30
40
1.0
50
0.40
35
1.0
50
0.30
40
".
Terminate the "Rinse Hold" option:
•
Press the "Rinse Hold" button again; the programme will terminate automatically with the
spin cycle for the present wash programme.
•
If you do not wish to spin the clothes, turn the drain programme and push on the "On/Off"
button again.
"Half Load" button
•
Reduces water consumption in the cotton and synthetic programme, above all during
prewash and rinse.
•
Especially suitable for lightly soiled or small loads (reduce the detergent quantity).
PROGRAMME START
Open the tap and press the "On/Off" button. The pilot lamp lights up.
DOOR LOCK
During the running programme the door can be opened for adding further laundry.
The door locks automatically in all programmes. If the programme is stopped or the electrical
power supply is terminated, the door lock will open after approximately 1 minute.
Note: If you open the door during the delicate or wool programme, there will be no spinning at
the end of the cycle but only draining. If you want to spin the laundry start the gentle spin
programme.
PROGRAMME END
•
The programme selector knob is at the end of the cycle.
1.
Press the "On/Off" button.
2.
Cancel the special options by pressing the appropriate buttons.
3.
Turn the water supply tap off.
4.
Wait for the door to unlock (about 1 minute).
5.
Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME
START
1.
Press the "On/Off" button to switch off the appliance.
2.
Select the new programme, temperature, spin speed and options.
3.
Press the "On/Off" button to switch on the appliance.
TO STOP, RESET A PROGRAMME BEFORE THE END
1.
Press the "On/Off" button to switch off the appliance.
2.
Set the programme selector to "Drain".
3.
Press the "On/Off" button to start the drain programme.
Only open the door when the programme selector is at the end of the cycle and the door is
unlocked (after approximately 1 minute).
GB
5019 100 12635
Advertisement
