Linksys Instant Wireless Series Fast Start Manual page 9

2. Static IP
If your ISP says that you are con-
necting through a static (or fixed)
IP address, perform these steps:
a. Select Static IP as the WAN
Connection Type.
b. In the fields beside "Specify
WAN IP Address", enter the IP
Address.
c. Enter the Subnet Mask.
d. Enter the Default Gateway
Address.
e. Enter the DNS in the 1, 2,
and/or 3 fields. You must enter at least one DNS address.
f. Click the Apply button to save the settings.
3. PPPoE
If your DSL provider says that you
are connecting through PPPoE or
if you normally enter a user name
and password to access the
Internet, perform these steps:
a. Select PPPoE as the WAN
Connection Type.
b. Enter the User Name.
c. Enter the Password.
d. Click the Apply button to save
the settings.
e. Click the Status tab, followed by the Connect button, to start the connection.
14
Instant Wireless™ Series
E
2
E
3
Wireless Access Point Router with 4-Port Switch
4. RAS
RAS is a service used in Singapore only. If you are using a RAS connection, check
with your ISP for the necessary setup information.
5. PPTP
PPTP is a service used in Europe
only. If you are using a PPTP con-
nection, check with your ISP for
the necessary setup information.
F. If you haven't already done so, click the Apply button to save the settings.
G. Reset the power on your cable or DSL modem and restart your computers.
They will now obtain the Router's new settings.
Note: You only need to configure the Router from one computer. If you need
advanced setting information, please refer to the Linksys support website at
support.linksys.com or the User Guide on the Setup Wizard CD-ROM.
Congratulations! You've successfully configured the Router. You can test the
setup by opening your web browser from any computer and entering
www.linksys.com/registration .
If you are unable to reach our
website, you may want to review what you did in this section or refer to the
Help section in this Fast Start guide.
E
5
15