Advertisement
Sticking Reset Button on Warm Bar
The warm bar has a clip that is tethered to the reset button. If excessive dirt builds up in the reset button, it may become
difficult to activate when pulled.
To resolve this, remove the reset button assembly (Fig. 1) from the warm bar and disassemble it to give it a thorough
cleaning.
It is strongly recommended that this procedure is done over a hard surface. There are a few
small components that can easily be lost in carpet.
The diagram below (Fig. 2) shows how the reset switch is assembled.
STAR TRAC FITNESS
E-TR and S Series Treadmills
Fig. 1
Fig. 2
1 of 3
Troubleshooting
637-1347 Rev: A
Advertisement
Table of Contents
Summary of Contents for Star Trac E-TR Series
- Page 1 It is strongly recommended that this procedure is done over a hard surface. There are a few small components that can easily be lost in carpet. The diagram below (Fig. 2) shows how the reset switch is assembled. Fig. 2 STAR TRAC FITNESS 1 of 3 637-1347 Rev: A...
- Page 2 The small pin must be in the middle of the plastic lever channel (Fig. 6) • Make sure the spring is in the right position (Fig. 7) • Fig. 6 Fig. 7 STAR TRAC FITNESS 2 of 3 637-1347 Rev: A...
- Page 3 Before reassembling the warm bar, verify that the reset button lever is in the proper positions (Fig. 8). It should not be between the switch and the arm (Fig. 9) Fig. 8 Fig. 9 After the warm bar has been completely reassembled, test to be sure the reset switch is working properly. STAR TRAC FITNESS 3 of 3 637-1347 Rev: A...
Need help?
Do you have a question about the E-TR Series and is the answer not in the manual?
Questions and answers