Table of Contents
Advertisement
Power Saving Mode
Parameter
Network Type
Transmit Power
Ad Hoc Wireless Mode
You may specify a SSID for the card and then only the device with
the same SSID can interconnect to the card. If you want to add
one of the networks nearby to the profile list, pull down the menu,
all the networks nearby will be listed and you can add one of them
to the profile list.
The power saving function is only available when the network type
is in Infrastructure.
CAM (Constantly Awake Mode) – The card will always set in
active mode.
Power Saving Mode – Enable the card in the power saving mode
when it is idle.
Description
Infrastructure – This operation mode requires the presence of an
802.11 Access Point. All communication is done via the Access
Point or Router.
Ad-Hoc – Select this mode if you want to connect to another
wireless station in the Wireless LAN network without going
through an Access Point or Router. Peer to Peer.
If you wish to lower the transmit power of the card to save the
power of your system, you can select the lower percentages from
the list.
When the card is set in Ad Hoc (Peer to Peer Mode), you can
designate the wireless connection mode for the Ad Hoc network.
802.11 B only – This card can be compatible with both 802.11g
and 802.11b wireless stations. If there are only 802.11b wireless
stations in the network, you can set the card to this mode.
802.11 B/G mix – If you have a mix of 802.11b and 802.11g
wireless stations in your network, it is recommended to setting
then card to this mode. This mode is also the default setting.
802.11 G only – This card can be compatible with both 802.11g
and 802.11b wireless stations. If there are only 802.11g wireless
stations in the network, you can set the card to this mode.
13
Advertisement
Table of Contents
