Checking The Chain Brake - Makita UC002G Instruction Manual

CAUTION: Before installing the battery
cartridge into the tool, always check to see
that the switch trigger actuates properly
and returns to the "OFF" position when
released.
NOTICE: Do not pull the switch trigger hard
without pressing the lock-off lever. This can
cause switch breakage.
NOTE: When you keep pulling the switch trig-
ger while the tool is under almost no load, the
rotation speed of the tool decreases and the
main power lamp blinks in green. In this case,
release the switch trigger, and then pull the
switch trigger again.
To prevent the switch trigger from being acci-
dentally pulled, a lock-off lever is provided. To
start the tool, depress the lock-off lever and pull
the switch trigger. The tool speed increases
by increasing pressure on the switch trigger.
Release the switch trigger to stop.
1
Fig.6
► 1. Switch trigger 2. Lock-off lever

Checking the chain brake

CAUTION: Hold the chain saw with both
hands when switching it on. Hold the top
handle with your right hand, the front han-
dle with your left. The guide bar and the
saw chain must not be in contact with any
object.
CAUTION: Should the saw chain not stop
immediately when this test is performed,
the chain saw may not be used under any
circumstances. Consult our authorized
service center.
1. Press the lock-off lever, then pull the switch
trigger. The saw chain starts immediately.
2.
back of your hand. Make sure that the chain saw
comes to an immediate standstill.
2
Fig.7
► 1. Front hand guard 2. Unlocked position
Checking the run-down brake
within two seconds in this test, stop using
the chain saw and consult our authorized
service center.
Run the chain saw then release the switch trig-
ger completely. The saw chain must come to a
standstill within two seconds.
13 ENGLISH
Push the front hand guard forwards with the
3
1
2
3. Locked position
CAUTION: If the saw chain does not stop
2
3