LightHeaded R3P-F-R-T Install Manual

1
Slide and click tabs onto
plate. Ensure mounting
holes line up for step 2a.
5a
5b
3a — Position trim hole to
desired location by sliding
housing
3b — Use centering holes on
either side of base plate to
line up a row of fixtures
info@lightheadedlighting.com
P. 604.464.5644 T. 1.800.464.9544
Install Guide
2
Align holes and screw
brackets to base plate.
5 6
To lock baseplate in place,
bend tab with pliers over
hanging bar.
R3P-F-R-T-installation • Subject to change without notice • REV 2021.10.19
.
www.lightheadedlighting.com
F. 604.464.0888
This product must be installed in accordance with the
applicable code by a person familiar with the construction
and operation of the product and the hazards involved.
Read all of these instructions before installing.
WARNING: Rated for non-insulated ceilings only (non IC rated)
WARNING: Disconnect power prior to servicing or installing.
3
Slide hanging bars onto
assembled base plate.
7
Mark approximate fixture
location in ceiling
R3P-F-R-T
NON-I/C BASEPLATE
4
Line up bottom edge of
hanging bars with bottom of
wood joist and hammer in
tabs. Nail or screw hanging
bars into place
8
Cut open using baseplate
hole as your guide
1