Troubleshooting - Glacier bay VAZON HD67248W-6010H Installation And Care Manual

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The aerator has an
irregular or reduced
water flow.
There is leaking from the
sink drain at the base of
the sink.
The water will not shut off
completely.
Reinstalling the cartridges:
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The aerator is dirty or mis-fitted.
The sink has a rough or irregular surface.
The rubber seat and spring under the handle
cartridge is dirty or broken.
2
1
2
1
□
□
□
□
□
□
□
□
□
□
a
b
Fig. 1
9
Please contact 1-855-HD-GLACIER for further assistance.
Solution
Tighten the bonnet nut.
Clean or replace the washer.
Remove the aerator and
check for debris.
Ensure that the rubber washer
is properly installed.
Apply additional silicone sealant
to the beveled side of the drain
flange.
Retighten and test for leaks.
Remove the handle.
Remove the cartridge to check
the rubber seat and spring.
Clean or replace.
When reinstalling the cartridges,
make sure the rubber seats and
springs (1) are below the
cartridge (2). The spring should
be installed first into the slot
and then the rubber seat. The
cartridge should then be installed
with the molded stops (a & b)
facing inward as shown in Fig. 1.
HOMEDEPOT.COM/GLACIERBAY