Advertisement
Primary Graphics Adapter PCI Express
:
Above 4G Decoding Disabled
:
VT-d: Enabled
SR-IOV Support: Disabled
DMI Link Speed : Gen3
PCIE1 to PCIE5 Link Speed Auto
:
PCI Express Native Control Disabled
:
PCIE ASPM Support Disabled
:
PCH PCIE ASPM Support Disabled
:
DMI ASPM Support Disabled
:
PCH DMI ASPM Support Disabled
:
Share Memory
: Memory allowed to the onboard graphics.
IGPU Multi-Monitor Disabled
:
Realtek 2.5G Ethernet Controller Enabled
Onboard HD Audio Auto
:
Front Panel HD HD
:
Onboard WAN Device Disabled
:
Deep Sleep Disabled
:
Restore on AC/Power Loss
: set it to
Turn on Onboard LED in S5 Disabled
Restore on Onboard LED Default: Disabled
RGB LED:
Off
1.3.3 Storage Configuration
SATA Controller Enabled
:
SATA Mode Selection:
AHCI / Intel RST Premium (RAID)
If you plan to use RAID array, you should install Windows with this setting set to Intel RST Premium (RAID), even if your system drive will not be in
the RAID Array.
You will need to add the RAID driver on your installation media, download it from the manufacturer website or use the Easy RAID installer feature
(see 1.4.3 below)
WARNING:
PMX V11/ Ovation V7 to PMX25th Hotfix2 / Ovation 9.0.5, MassCore users running a RAID configuration must use a dedicated RTX
dongle (SSK-HUD-RTX) to authorize MassCore.
This issue only affects the system (Windows ) RAID drives, if you have RAID Data drives, a dedicated dongle is not required.
Since PMX25th Hotfix3 / Ovation 9.0.6, the RTX dongle SSK-HUD-RTX is no longer mandatory.
To configure your RAID array, please see the RAID Installation notes below.
SATA Aggressive Link Power Management Disabled
Hard Disk S.M.A.R.T. Enabled
:
SATA_0 to 5
:
External SATA
: enable if the drive uses eSATA (External Drives for example).
Hot plug
: enable if you need Hot-Plug capability (Drive trays for example).
SATA device type
: set to Solid State Drive or Hard Disk Drive
1.3.4 Intel® Thunderbolt
Discrete Thunderbolt(TM) Support Disabled
1.3.5 Super I/O Configuration
PS2 Y-Cable Auto
:
1.3.6 ACPI Configuration
Suspend to RAM Disabled
:
PS/2 Keyboard S4/S5 Wakeup Support Disabled
PCIE Devices Power On Disabled
:
RTC Alarm Power On: By OS
USB Keyboard / Remote Power On Disabled
USB Mouse Power On Disabled
:
1.3.7 USB Configuration
Legacy USB Support Enabled (if set to disable, no USB Support until OS is booted)
:
XHCI Hand-off Disabled
:
USB Single port Control
: all should be set to
1.3.8 Trusted Computing
if you use a separate graphic card (recommended - only displayed if your CPU supports this feature)
:
Power On
if you want the system to restart after a power failure.
:
:
:
:
:
Enabled
Auto
for dedicated graphic card. (set to 1024M if you use onboard graphics)
Advertisement
