Error Codes; Basic Command Reference - Matrix Switch Corporation MSC-CP8X4E Product Manual

LEVEL
PRESET
IP
NETMASK
JSON
LABEL
STR

3.6 Error codes

This following table shows possible error codes which may be returned in response to commands.
Error # Message
E01 Token too long
E02 Invalid command
E03 Invalid argument
E04 Invalid destination
E05 Invalid source
E06 Invalid level
E07 Invalid preset
E08 Unterminated string
E09 Backspace limit
reached
E10 HTTP buffer overflow
E11 Serial receive overrun
E12 Unsupported command Command is not supported by the system or current

3.7 Basic command reference

Basic commands consist of those commands which are used for modifying routing and other simple commands.
Mascot version where a command was added is indicated in parenthesis, (2.3) for example.
Page 18 of 48
MSC-CP8X4E Product Manual
1-N Level number (N = Count of system levels)
0-9 Preset number (preset 0 is special Startup preset)
D.D.D.D IP address string argument, specified as 4 decimal
digits from 0 to 255 separated by periods.
D.D.D.D Network mask string argument, specified as 4
decimal digits from 0 to 255. Must be a valid
IPv4 netmask.
string JSON formatted string, the structure of which
depends on the command. The JSON string
should be quoted in single quote characters when
specifying a JSON value in a command.
string A string label argument, max of 8 characters.
string A generic string argument (max length depends
on the command).
Description
A command name or string argument was too long.
Invalid command name.
One or more invalid argument values.
Invalid matrix destination number.
Invalid matrix source number.
Invalid matrix level number.
Invalid preset number.
Double or single quoted string not terminated.
Devices have a limited backspace buffer size, if too
many characters are backspaced and then more
characters are appended, this error will occur.
Only applicable to the web page command interface.
Unlimited command input or output can be handled,
but not both.
One or more characters were lost on the serial
interface.
configuration. Firmware 5.3.0 and newer.
Copyright © 2013-2015 Matrix Switch Corporation www.matrix-switch.tv