Table of Contents Introduction I. Unpacking II. Installation and Connections III. Features and Operation IV. Initial Operating Setup SCA-100 Optional Programming Functions 5-6 Remote Control Connections Analog Audio Input Connector Wiring Serial RS232 Connector Wiring V. Specifications VI. Warranty...
Select a space in suitable E.I.A. standard rack to locate the unit. Determine the local electrical power supply voltage. As supplied from the factory, your SCA-100 is setup for 100 – 240 V.A.C. 50 - 60 Hz. No external adjustment for local power standards is necessary if power available conforms to the above rating.
Page 4
Once you enter the default IP address this screen should appear: Press Setup and the IP setup page will appear: Make changes and hit save but make sure you record the settings before exiting this screen. It is a good idea to take as screen shot or record the username, password and IP address information here: Username: __________________________________________________ Password: ___________________________________________________...
In order for the setting to take effect the unit must be power cycled for at least 5 seconds. Once the unit is confirmed on the desired IP address load the SCA APP supplied on the accompanying CD ROM onto a computer. Once installed you can start the app by clicking on the EXE file.
Page 6
UP/DOWN arrows. It is advisable to feed an audio signal in that is processed with at least some form of peak limiter to limit modulation of the generator. The SCA-100 does no dynamic processing of the audio feeding it. This must be done ahead of the unit.
Remote Control – Parallel/GPIO DB25F Connection Table 2. Command input pins require a momentary closure to common. Status connections open collector outputs which require a 5 VDC pull up which is provided on pin 12. CUST SUPPLIED SCA GEN 1 INPUT A SEL COMMAND CMD/STAT COM SCA GEN 1 A INPUT SELECTED STATUS SCA GEN 1 INPUT B SEL COMMAND...
Specifications Digital Inputs: Four – XLR or BNC, model dependent Analog Inputs: Four- balanced stereo + 4 dBm nominal level Digital Outputs: Two – XLR or BNC, model dependent Analog Output: Balanced L/R XLR + 4 dBm 600 Ohms – Rear Panel Headphone out: 600 Ohm unbalanced - Front Panel Sample Rate Range:...
Broadcast Devices, Inc. products are warranted against failure due to faulty materials or workmanship for a period of one year from the date of shipment from Broadcast Devices, Inc. dock. The warranty covers repair or replacement of defective parts at the factory, provided the unit has been returned prepaid by the user.