Page 1: Table Of Contents
General danger warnings and preventive safety Assembly instruction / Fixing the mechanism Emergency manual releases Limit switch setting Star/Delta voltage connection Annual check Technical specifications Technical dimensions Declaration of conformity DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany info@das-automation.com...
Page 2: General Information
• This manual contains important instructions and warnings regarding safety. Incorrect installation may cause serious injury. Before commencing work, all sections of the manual must be read carefully. If in any doubt, suspend installation and call the DAS Support Service for clarification.
Page 3 • the possible reasonably foreseeable misuse and, whenever relevant, a warning against the effects it may have on the safe use of the appliance. DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany info@das-automation.com...
Page 4: General Danger Warnings And Preventive Safety
Fixing must be performed using 4 M 8x12 screws and the washers supplied. Tightening torque must be 20 Nm. The support is to be secured on the building side with 2 8/M10 screws. DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany...
Page 5: Emergency Manual Releases
WARNING: Max. chain length: 14 meters - max. assembly height 8 m!!! NOTE: with chains having lengths min. 15 meters it is necessary to use the “2” chain release. DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany...
Page 6: Limit Switch Setting
During assembly simply insert the six-pole plug. Mechanical settings and positionings are not needed. The terminals for the safety chain (safety switch) are respectively located on the Evotronix magnetic limit switch. See following picture: DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany info@das-automation.com...
Page 7: Star/Delta Voltage Connection
Maintenance interventions on windows, doors and main doors with mechanical operation must be performed only by personnel authorized by the company, having the necessary experience and skills (BGR 232). DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany info@das-automation.com...
Page 8: Technical Specifications
NOTE: all the technical characteristics indicated refer to a temperature falling between -5°C and +40°C. • DAS reserves the right to change all the modifications to the product it deems necessary at any time but keeping the functions and intended use unaltered.
Page 9: Technical Dimensions
Manual Sectional Door Drive TECHNICAL DIMENSIONS DAS – Deutsche Antriebs und Steuerungstechnik GmbH Otto-Hahn-Str. 3 • 48301 Nottuln • Germany info@das-automation.com...