Advertisement
KI
PH: (269) 382-2050
TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS EQUIPMENT TO RAIN, ANY LIQUID OR MOISTURE
If these goods are damaged in transit, the DELIVERING TRANSPORTATION
COMPANY is required by law to make notation of damages on the freight bill. If in your
opinion, there may be concealed damage, they are required to make an inspection after goods are
unpacked. Transportation rates are made in proportion to damage. Therefore, the carrier and
NOT the shipper should be charged with any loss or damage. Any claim should be filled with
the delivering TRANSPORTATION COMPANY. PLEASE DO NOT RETURN GOODS
TO US WITHOUT OUR RGA NUMBER AND SHIPPING INSTRUCTIONS.
NOTE: SEE NEXT PAGE FOR RETURN POLICY AND WARRANTY.
1. Disconnect power before making any adjustments.
2. Abrasive belt rotation is counter-clockwise. If the abrasive belt is lap spliced be sure of the correct belt
rotation. Butt spliced belts bi-directional.
3. Belt tension is pre-set with internal spring (12). No belt tension adjustment is required.
4. To change belt disconnect power, loose tracking knob (22), open belt guard (17), compress spring belt
tension by pushing down on tension shaft (13), remove belt and replace with new belt of your choice.
5. Belt tracking- with power disconnected rotate belt by hand to center or "track" sanding belt. Rotate tracking
knob (22) and tracking collar (21), left and or right turns the tension shaft (13) to "track" the belt. Re-lock
the tracking knob (22) to lock in belt tracking. Close belt guard (17) and reconnect connect power.
KALAMAZOO
INDUSTRIES, INC.
KALAMAZOO, MI
WARNING!
INSPECTION
IMPORTANT
Read Operating Instructions before using equipment.
OPERATING INSTRUCTION
www.kalamazooind.com
.
Advertisement
