Advertisement
Table of Contents
COPYRIGHT © STANWOOD IMPORTS & ORIENTAL TOUCH LLC
HOW TO ASSEMBLE YOUR
CWS-01 -02 -03 -01L -02L
STEP 1.
Gather these parts: one pole with beveled
edge and three support stakes.
STEP 3.
Slide a support
stake into the
main pole
and hammer it
into the ground.
STEP 5.
Slide a third
support stake on
to the main pole.
Position it evenly
away from the first
two stakes and
hammer it into the
ground.
* We recommend you use blue Loctite thread locker if in windy area
WIND SCULPTURES
Installation: Pole Anchoring
STEP 2.
Hammer the
main pole into
the ground
using a Rubber
Mallet until the
black line
touches the
ground (about 1
ft. deep).
STEP 4.
Slide a second
support stake
into the main
pole. Position it
~120 degrees
away from the
first stake and
hammer it into
the ground.
STEP 6.
1
Advertisement
Table of Contents
Related Manuals for Stanwood CWS-01
Summary of Contents for Stanwood CWS-01
- Page 1 COPYRIGHT © STANWOOD IMPORTS & ORIENTAL TOUCH LLC HOW TO ASSEMBLE YOUR WIND SCULPTURES CWS-01 -02 -03 -01L -02L Installation: Pole Anchoring STEP 2. STEP 1. Hammer the Gather these parts: one pole with beveled main pole into edge and three support stakes.
- Page 2 COPYRIGHT © STANWOOD IMPORTS & ORIENTAL TOUCH LLC Installation: Wind Sculpture STEP 8. STEP 7. Mount spinner wheels onto the T-shaped Connect two shaft with the exposed sections of the side of the bearings pole together. facing away from the T shaft.
Need help?
Do you have a question about the CWS-01 and is the answer not in the manual?
Questions and answers