Advertisement
THIS SIDE UP FOR LHR DOOR
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
801 Avenida Acaso, Camarillo, CA 93012
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com
TEMPLATE-S6201
Devices covered by this template:
Panic / Fire SVR Exit Device Exit Only.
P:\INST INSTRUCTIONS\EXIT DEVICES\TEMP-S6201
REV B
03-22
FOLD HERE
CAUTION
DO NOT USE DOOR EDGE
L C
OF
DEVICE
TO FACE OF STOP
BACKSET 2-7/16"
FOLD HERE
Page 1
(4x) DEVICE MOUNTING HOLES
METAL:
DRILL / TAP FOR 1/4"-20 MACHINE SCREWS
WOOD:
PRE-DRILL 1/8" HOLES.
SEXBOLTS:
DRILL 5/16" CLEARANCE HOLES ON PUSH SIDE,
3/8" HOLES ON PULL SIDE.
2"
3-11/16"
3-11/16"
AFTER EXIT DEVICE IS MOUNTED,
INSTALL END CAP BRACKET
CENTERED ON DEVICE C L
40"
Watch for special
mounting height
requirements
2"
FINISHED FLOOR
(2x) END CAP BRACKET HOLES
METAL:
DRILL / TAP FOR 1/4"-20
MACHINE SCREWS.
9/16"
WOOD:
PRE-DRILL 1/8" HOLES.
SEXBOLTS:
DRILL 5/16" CLEARANCE
HOLES ON PUSH SIDE, 3/8" ON
PULL SIDE.
1-3/16"
19/32"
OPTIONAL 1/2"dia.
WIRE RUN
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
Advertisement
Table of Contents
Summary of Contents for SDC S6201
- Page 1 40" Watch for special mounting height requirements 2" FOLD HERE Any suggestions or comments to this instruction or FINISHED FLOOR product are welcome. Please contact us through our website or email engineer@sdcsecurity.com P:\INST INSTRUCTIONS\EXIT DEVICES\TEMP-S6201 REV B 03-22 Page 1...
- Page 2 PLACE THIS SIDE ON DOOR SURFACE SIDE 2-3/8" (2x) TOP LATCH HOLES METAL: DRILL / TAP FOR 1/4-20" MACHINE SCREWS WOOD: PRE-DRILL 1/8" HOLES 5-19/32" 3-7/32" TOP LATCH C of BACKSET BACKSET LATCH 2-7/16" 2-7/16" P:\INST INSTRUCTIONS\EXIT DEVICES\TEMP-S6201 REV B 03-22 Page 2...
- Page 4 PLACE THIS SIDE ON FOLD HERE DOOR SURFACE INSIDE. 1/4" PLACE THIS SIDE ON TOP OF FINISHED FLOOR FINISHED FLOOR OR TOP OF 27/32" PANIC THRESHOLD DRILL Ø 3/4" HOLE 2-1/8" DEEP 1-13/16" P:\INST INSTRUCTIONS\EXIT DEVICES\TEMP-S6201 REV B 03-22 Page 3...
Need help?
Do you have a question about the S6201 and is the answer not in the manual?
Questions and answers