Download Print this page

RACOR PG-2R Instructions

Golf storage hanger

H O M E

S T O R A G E P R O D U C T S

TOOLS REQUIRED

Phillips driver

1/8" Drill bit

Drill

Please read installation instructions carefully prior to installing. Before

using the product thoroughly test the fully-weighted product (with equip-

ment in place) to ensure the product has been installed properly. Do not

allow children to play on product. ITW Brands is not responsible for any

damage resulting from improper installation, overloading or product

failure.

Mark holes through level rack mounting plates,

drill 1/8" pilot holes and install screws into

stud. Tighten screws ﬁrmly.

GOLF STORAGE HANGER | PG-2R

INSTRUCTIONS

Golf rack

2'' (5 cm) wood screws

Table of Contents

Do you have a question about the PG-2R and is the answer not in the manual?

Page 1 H O M E S T O R A G E P R O D U C T S GOLF STORAGE HANGER | PG-2R INSTRUCTIONS TOOLS REQUIRED PARTS LIST Phillips driver Golf rack 1/8” Drill bit Drill 2’’ (5 cm) wood screws WARNING Please read installation instructions carefully prior to installing.
Page 2 SHOE PLACEMENT 2 pairs of shoes may be placed on the rack by sliding them onto the wire loops either upside down or rightside up. BAG PLACEMENT USING THE GOLF RACK Golf bags are stored on the rack by hanging Hang golf bags on either side and either carrying handles or shoulder straps over place shoes on center hooks as shown.