Classic Accessories 52-041-010401-00 Instructions

Instructions: Log Splitter Cover

WARNING!
Do not operate the log splitter with the cover on.
CAUTION!
Let your log splitter cool before you put the cover on.

Fitting

Your Log Splitter Cover fits gas or electric log splitters up to 82 in. L x 45 in. W
x 34 in. H (when in horizontal position). It does not cover some accessories.

Installation

Check your log splitter for sharp corners or edges that could stress your cover as you pull
it on. Look for a yellow tag sewn in the bottom hem that says, "front". Slip your cover over
the top of your log splitter with the yellow tag at the front, then pull the cover down on all
four corners. To insure a snug fit, once you have the cover into place, adjust the elastic cord
along the bottom.

Use and Storage

Your Log Splitter has an integrated storage bag. To fit your cover in the bag fold and roll it
tightly rather than stuffing it. Never store a wet cover in the storage bag or confined area
as the cover can be damaged by mildew.

Cleaning and Care

Clean your cover with a soft brush and luke-warm water. DO NOT USE SOAP as it may
remove the protective coatings added by the factory. Air dry.
52-041-010401-00
10 cH51_11724
do not
use soap
do not iron
line dry
no tools
required
CLASSIC ACCESSORIES, INC.
KENT, WA USA 98032 ©2010
c l a s s i c a c c e s s o r i e s . c o m
do not
pack wet
no bleach
water
resistant