Lalizas 70168 Service Manual

Inspection Device for Immersion suits
The aluminum kit contains a set of Servicing Equipment.
A
Face fixture (two parts)
B
Pressure gauge (0-6kPa)
C
Foot pump (with multi-valve adaptor)
D
Glue and applicator (two pieces)
1. Lay the immersion suit on a work table and check for damages.
3. Place Face Fixture (Part 2), by adjusting its holes
carefully through the bolts and joints.
70168

Instruction process

1. Adjust the air-pressure test cevice on the immersion suit

Part 1, Face Fixture

Part 2, Face Fixture

Service Manual
for the air- pressure test & repair of immersion suits
C
A
2. Place Face Fixture (Part 1) inside the immersion suit hood area
and zip up. Attention: Stretch the hood fabric by pulling it to the
direction of arrows. The hood should not have any folds.
4. Above is an example image of assembled face fixtures with
Attention:
hood. The zipper head should pass through the hole.
B
D
01
www.lalizas.com