DeVilbiss MPV-616 Operation Manual
DeVilbiss MPV-616 Operation Manual

DeVilbiss MPV-616 Operation Manual

Air-fed vizor outfit

Advertisement

Quick Links

SB-EE-25-048
ISS.04
OPERATION MANUAL
MPV-616 AIR-FED VIZOR OUTFIT
E
E
P 1 - 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MPV-616 and is the answer not in the manual?

Questions and answers

Summary of Contents for DeVilbiss MPV-616

  • Page 1 SB-EE-25-048 ISS.04 OPERATION MANUAL MPV-616 AIR-FED VIZOR OUTFIT P 1 - 8...
  • Page 2 The MPV supplied air-fed vizor respirator is CE from particles, fumes, gases and vapours. The approved under PPE Directive 89/686/EEC. respirator should only be used with Devilbiss The visor conforms to European Eye-Protection original components to maintain approval for the...
  • Page 3 Disposable lbf/in²). carbon odour removal filter and pre-set regulator Supply hose - Only to be used with Devilbiss in a moulded housing which is moveable on the original hose. The manufacturers flow rate is belt.
  • Page 4 BSEN 12021:1999 AND THE RELEVANT HOSE LENGTH: Note 10m is the maximum NATIONAL AND LOCAL STANDARDS. hose length that can be used due to the ONLY USE RECOMMENDED DEVILBISS minimum pressure requirements. SUPPLY HOSE If longer hose length is required a portable...
  • Page 5 REPLACEMENT OF PARTS DISPOSABLE CARBON FILTER (14): FACEMASK & SEAL ASSEMBLY (3) 1) Unscrew the three cross head screws holding Unclip and remove hose and foam diffuser. Push the regulator (13) to the filter housing (15). the acetate visor inwards at the top where it 2) Remove the spent filter (14) from the filter attaches to the browguard to release the two housing (15) and replace with a complete new...
  • Page 6 Note Kit quantities do not apply to outfits, see quantities specified in outfit column. OT PART OF OUTFIT ORDER SEPARATELY Use of this Devilbiss supply hose is essential to ensure correct and safe operation of this equipment. DESCRIPTION PART DESCRIPTION...
  • Page 7 © 2003 ITW Finishing Systems and Products...
  • Page 8 ITW Finishing Systems and Products is a Division of ITW Ltd. ITW Finishing Systems and Products Reg. Office: Ringwood Road, Admiral House, Bournemouth, St Leonard’s Road, BH11 9LH, Windsor, England. Berkshire, Tel. No. (01202) 571111 SL4 3BL, Telefax No. (01202) 581940, Website address http://www.devilbisseu.com Registered in England: No 559693 Vat No 619 5461 24 http://www.itwifeuro.com.

Table of Contents