Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Touchstone Manuals
  4. Patio Heater
  5. 40001
  6. Instruction manual

Touchstone 40001 Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
Model # 40001
CITADEL Pyramid Heater

Advertisement

loading
Need help?

Need help?

Do you have a question about the 40001 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Touchstone 40001

  • Page 1 Model # 40001 CITADEL Pyramid Heater...
  • Page 3 All screws come preinstalled in related parts. WARNING This product can expose you to chemicals including carbon monoxide which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
  • Page 5 (Top: 32 in Side: 26 in)
  • Page 7 screws Not Provided M5X8 Wing Nut Reflector Studs...
  • Page 8 Hardware Used: 4x Bolts and Nuts Hardware Used: 3x Bolts and Nuts (pre-assembled) (pre-assembled to Brackets) 2.Locate the propane cylinder bracket (11) and 1.Attach wheels (10) to bottom plate (1) . attach it on the bottom plate with 3 bolts and nuts provided with the bracket.Use the M8x45 screw to secure the propane cylinder.
  • Page 9 Opening on Base is opposite side of wheels. Note location of door guides on bases (Not Included) Hardware Used: 1x AA Battery Hardware Used: 1x Rubber Ring 4x Screws 5.Unscrew the red igniter button on the control 6.Carefully put the glass tube (7) up through the center of the hole in the upper plate (4).Make sure the rubber box and insert the AA battery (17) with the ring (18) is attached on the lower end of the glass tube.
  • Page 10 Remember to remove protective film from reflector. Hardware Used: 3x Studs Hardware Used: 4x Screws 3x Wing Nuts 7. Attach the bolts onto the damper (4),and put 3pcs 8.Attach the protection guards (9) to the upper frame by washer onto the bolts,then put the reflector (8) inserting the hooks at the top of the guards into the holes onto the bolts,put 3pcs washer through the bolts on the supports.
  • Page 11 10.Screw the handle (15) on the front panel (14) - attach the panel by inserting its two hooks into the holes on the bottom plate.Hook the chain (16) to the hole in the control box,then close the panel to the middle plate - the panel is attached by the magnets. Tips:the chain can hole the panel while operating the control.
  • Page 12 3. Check for the pilot flame through the glass tube. If the pilot does not light, press and turn the PILOT your LPG cylinder when the heater is not in use.
  • Page 14 AA battery is missing or dead Replace AA battery...