Table of Contents
Advertisement
11. TROUBLESHOOTING
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
programme or
option.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The
On/Off button was not
pushed.
The
Start/Pause button was
not touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Dryness option was set to
4)
iron dry .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi-
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possible
to change the programme or op-
tion.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do-
mestic installation).
Close the door.
Push the
On/Off button.
Touch the
Start/Pause button.
Push the
On/Off button.
Select a suitable programme.
3)
Clean the filter.
Change
Dryness option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
ENGLISH
21
2)
5)
3)
Advertisement
Table of Contents
