Advertisement
TONNEAU COVER FITTING INSTRUCTION
SINGLE CAB WITHOUT SPORT BAR
BASIC TOOLS REQUIRED
Drill, 4mm Drill Bits, Rivet Gun, Marking Pencil/ Pen
CONTENTS
-
1 x Tonneau Cover
-
2 x Tonneau Support Bar
-
1x Fitting Instruction
1. INSTALLATION PROCEDURE
NOTE:
Read entire instructions prior to start.
STEP 1
Fit the front of the Tonneau to the front of the Ute tub placing the LTD clips (Fitted on the
Tonneau Cover) on to the LTD posts already fitted on the body.
(Behind rear windscreen).
STEP 2
Fit your tonneau cover support bar/s into position (Refer to the instructions below)
STEP 3
Drape cover over support bars.
STEP 4
Fit Bunji Loops to Body Hooks, starting at the rear then fitting the side's bunjis.
STEP 5
Your Tonneau Cover is now fitted.
2. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu
Brumbys to Cab Chassis aluminium trays.
2.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
-
2.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
HOLDEN VG VR VS
1990 – 2001
PART NO: ATB01063
-
2 x grub screws
-
4 x Bar Brackets
-
8 x Rivets
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HOLDEN ATB01063
Summary of Contents for HOLDEN ATB01063
- Page 1 TONNEAU COVER FITTING INSTRUCTION HOLDEN VG VR VS SINGLE CAB WITHOUT SPORT BAR 1990 – 2001 PART NO: ATB01063 BASIC TOOLS REQUIRED Drill, 4mm Drill Bits, Rivet Gun, Marking Pencil/ Pen CONTENTS 1 x Tonneau Cover 4 x Bar Brackets...
- Page 2 2.3 FITTING MULTI-FIT BAR 1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
Need help?
Do you have a question about the ATB01063 and is the answer not in the manual?
Questions and answers