Page 1
6. Install at the center of the door leaf to prevent deformation whenever it is locked or unlock. Specifications Model Notes EL-250 Item Power Supply DC 12V / DC 24V Current 450mA / 12VDC 235mA / 24VDC Monitor Output N.O / N.C...
Page 2
Voltage and Delay Time Adjusting Control Panel Wiring hole Delay time switch Adjusting Volatge Door open switch Voltage Indicator light adjusting Jump External door open push button Delay time Setting Attention 1. Door open buttons have both built-in and external inputs. Please use both V- and P.S. Points for external door open button.
Page 3
Step 3: Remove the upper cover (C) of the handle and then the lower cover(C-1) by removing two screws (A-1 B-1) to pull out plate(D).(Please refer to Fig5-Fig6) Step 4: Use two attached screws to screw the handle onto the appropriate position of the installation holes when D is pulled out.(Please refer to Fig 7) Do not screw tight as to adjust both handle and body lock positions well by closing the door for several times to make sure both of them are matched.
Page 4
Right opening door Optional plate Optional EL-250P plate (thickness of 3.6mm) is available to achieve optimum height of both door frame and door leaf when the unit is installed. EL-250P Door Door Frame Leaf EL-250P Q & A Door is not locked light. 1.