The table in this section shows the factory default settings for all inputs to give you a picture of the AVR 445's initial settings. You may then decide
whether any item needs to be changed so that it is more appropriate for your specific installation. Any of the settings shown may be changed as shown
in the System Configuration section of the owner's manual.
TABLE 1: INPUT DEFAULTS
INPUT
Video 1
Video 2
Video 3
Video 4
DVD
HDMI 1
HDMI 2
Tuner
XM
CD
Tape
DMP/The Bridge
6/8 CH Direct
USB
System Default and Personal Settings Worksheets
The worksheets in this section show the system defaults for the global settings on your AVR 445. Once your system is configured manually, or
through the use of EzSet/EQ II, where applicable, we recommend that you use the "Your System Settings" column to record your personal preferences
so that they may be restored in the event the AVR's memory is lost due to an extended power outage, system upgrade, processor reset, or
other major service to your unit.
Worksheet A: Surround Configuration Defaults and Settings
Page 1
SYSTEM DEFAULTS The table in this section shows the factory default settings for all inputs to give you a picture of the AVR 445’s initial settings. You may then decide whether any item needs to be changed so that it is more appropriate for your specific installation. Any of the settings shown may be changed as shown in the System Configuration section of the owner’s manual.
Page 2
AVR 445 SETTINGS WORKSHEETS Worksheet B: Delay Defaults and Setting Feature System Default Front Left Center Front Right Surround Right Surround Back Right Surround Back Left Surround Left Subwoofer Worksheet C: System Defaults and Settings Feature System Default Front L/R Speaker Size & X-Over Small –...