SINOX SXEC1635 Manual

Charging Cable Manual
SXEC1635 | SXEC3215 | SXEC3235

How to use mode 3

Female plug

male plug

You start a session at a charging point using a registered RFID card.
To start a session, hold your RFID card in front of the RFID symbol
beneath the display on the front of the charging point.
After successful authorization the charging point is ready and the
sockets are opened. Plug your charging cable into either the right or
the left side.
Now connect your charging cable to your EV.
As soon as the connection between the vehicle and the charging
point is established, the charging cable will be locked and the
charging process will start.
You can end the charging process by again holding your RFID card in
front of the RFID symbol. The plug will be unlocked.
The plug attached to the EV can now be pulled out.
Pull the plug out of the charging point.
www.sinox-europe.com
Sinox Europe A/S Troensevej 11. DK-9220 Aalborg.