Table of Contents
Advertisement
If it seems that your housing lens port might be compatible with the type-B adaptor setup,
you might consider replacing the preassembled type-A adaptor with type-B adaptor:
a. Place the lens on a working surface so that the dome is facing downwards and the
thread is facing upwards. To protect the lens, cover the working surface with soft
cloth and leave the front neoprene cover assembled on the lens.
b. Remove the rear cap of the lens by unscrewing it until it separates from the lens.
c. Use the Allen Key (2.5mm) included
with the Type B Adaptor Kit in order
to unscrew all of the screws installed
on the rear side of the lens (image
#2).
d. Remove the type-A adaptor from the
lens and install the type-B adaptor
instead, so the screw holes on the
adaptor are aligned with the screw
holes on the lens.
e. Using the 2.5mm Allen Key, reinstall
the screws to secure the type-B
adaptor in place.
f. Test the configuration by screwing
the lens on to your housing lens port
(image #3 and 4). If the lens properly screws all the way in and sits within a fixed and
stable position, the configuration is most likely compatible with your housing.
Otherwise, replace the type-B adaptor with the type-A adaptor again.
Image #3
5
Image #2
Image #4
AOI UWL-09Pro Wide Angle Lens Instruction Manual 20190213
Advertisement
Table of Contents
